Decaura 55705 Pull Out Sink Mixer Instruction Manual
- July 23, 2024
- Decaura
Table of Contents
Decaura 55705 Pull Out Sink Mixer
Pull Out Sink Mixer
- For Model Code: 55705, 57305
Please check over carefully the surface and accessories to avoid any damage and missing part.
| No. | Description | Quantity |
|---|---|---|
| 1 | Sink Mixer | X1 |
| 2 | Rubber Washer | X1 |
| 3 | Gasket | X1 |
| 4 | Fixating Nut | X1 |
| 5 | Gravity Ball | X1 |
| 6 | Inlet Hose | X2 |
Instructions
- Working pressure: 0.05-1 Mpa, Working temperature: 0-55 °C.
- Products are manufactured as per standard AS/NZS 3718:2005. as per Australian standard, and with Water Mark & WELS certificate as shown in the packing.
- All surfaces should be cleaned with water or mild liquid detergent. Do not use cream cleaner or citrus based or chemical cleaning products.
Warranty Terms
All products are guaranteed as below:
- 5 years guarantee against main body. finishing and cartridge.
- 2 years guarantee on washers and O-rings.
Installation Steps
Step 1
Unscrew the fixing nut, stainless steel gasket and rubber washer from the kitchen tap.
Step 2
Cross all hoses through the countertop hole and hold the faucet body.
Step 3
Put the rubber washer, stainless steel gasket and fixing nut through the pull out hose, screw the fixing nut by hand and fasten it, then use a Phillips screwdriver to tighten the two screws until it is stable enough. Then connect the water inlet hoses to two copper ends in red and blue tightly.
Step 4
Inset the pull out hose end into the plastic connector. Make Sure the hose is
properly engaged and secured in the plastic connector.
Fix the gravity ball where the label specified, tightly fasten the tow screws.
Then pull out the shower head and release it for several times to check if it
is working smoothly.
Connect the two water inlet hoses to the angle valve as per red/blue mark.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>