Decaura 55505CH Kitchen Mixer Tap Pull Out 2-Mode Sprayer Laundry Tap Sink Faucet Swivel Spout Instruction Manual
- June 14, 2024
- Decaura
Table of Contents
Decaura 55505CH Kitchen Mixer Tap Pull Out 2-Mode Sprayer Laundry Tap
Sink Faucet Swivel Spout
Pull Out Sink Mixer
- For Model Code: 55505CH, 555058K, 55505NK, 55505SG
Many thanks for purchasing Decaura products, please check over carefully the surface and accessories to avoid any damage and missing parts.
Instructions
- Working pressure: 0.05-1 Mpa, Working temperature: 0-55°
- Products are manufactured as per standard AS/NZS 3718:2005. as per Australian standards, and with WaterMark & WELS certificates as shown in the packing.
- All surfaces should be cleaned with water or mild liquid detergent. Do not use cream cleaner or citrus-based or chemical cleaning products.
Warranty Terms
All products are guaranteed as below:
- 5-year guarantee against the main body. finishing and cartridge.
- 2 years guarantee on washers and O-rings
Installation Steps
-
Unscrew the fixing nut, stainless steel gasket, and rubber washer from the kitchen tap.
-
Cross all hoses through the countertop hole and hold the faucet body.
-
Put the rubber washer, stainless steel gasket and fixing nut through the pull-out hose, screw the fixing nut by hand and fasten it, then use a Phillips screwdriver to tighten the two screws until it is stable enough. Then connect the water inlet hoses to two copper ends in red and blue tightly.
-
Insert the pull-out hose end into the plastic connector. Make Sure the hose is properly engaged and secured in the plastic connector. Fix the gravity ball where the label is specified, and tightly fasten the two screws. Then pull out the shower head and release it several times to check if it is working smoothly. Connect the two water inlet hoses to the angle valve as per the red/blue mark.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>