Decaura 71611CH Basin Mixer Instruction Manual
- June 14, 2024
- Decaura
Table of Contents
Decaura 71611CH Basin Mixer
Installation Manual
Basin Mixer
- For Model Code: 71611 CH, 71611 BK, 71611 SG 7163 ICH, 71631 BK, 71631 SG
Please check over carefully the surface and accessories to avoid any damage and missing parts.
| No. | Description | Quantity |
|---|---|---|
| I. | Mixer Tap Body | xi |
| 2. | Screw Tube | xi |
| 3. | Rubber Washer | xi |
| 4. | Stainless Steel Gasket | xi |
| 5. | Fixing Nut | xi |
| 6. | Inlet Hose | x2 |
Instructions
- Working pressure: 0.05-1 Mpa, Working temperature: 0-55°C.
- Products are manufactured as per standard AS/NZS 3718:2005. as per Australian standards, and with WaterMark & WELS certificate as shown in the packing.
- All surfaces should be cleaned with water or mild liquid detergent. Do not use cream cleaner or citrus-based or chemical cleaning products.
Warranty Terms
All products are guaranteed as below:
- 5-year guarantee against the main body, finishing and Cartridge.
- 2-year guarantee on washers and O-rings.
Installation Steps
Step I
Unscrew the fixing nut, stainless steel gasket and rubber washer from the
small basin tap. Take off the rubber washer, stainless steel gasket and fixing
nut from the screw tube.
Step 2
Connect the inlet hoses to the copper pipes and rotate them tightly. Then
slide the single-hole faucet through the mounting hole.
Step 3
Place the rubber washer and stainless steel gasket to the screw tube and
tighten the fixing nut securely as shown. Remember to use the driver’s crew to
tighten the screw in the nuts on both sides.
Step 4
Connect and tighten the Hot and Cold supply hose to the valve and check any
leakage before use.
Notice: It is important to flush out the water supply pipes before connecting the hose to the angle valve. This procedure will prevent foreign objects from entering the cartridge.