Decaura 8580CH Rain Shower Set Installation Guide
- June 14, 2024
- Decaura
Table of Contents
Installation Manual
8580CH Rain Shower Set
Rain Shower Set
– For Model Code: 8580CH, 8580BK, 8580-2CH, 8580-2BK (In different shower
heads only)
Many thanks for purchasing Decaura products, please check over carefully the
surface and accessories to avoid any damage and missing parts.
| No. | Description | Quantity |
|---|---|---|
| 1 | Main Pipe | x1 |
| 2 | Decoration Base | x1 |
| 3 | Diverter | x1 |
| 4 | Connector | x1 |
| 5 | Shower Head | x1 |
| 6 | Handheld Shower | x1 |
| 7 | .5m Shower Hose | |
| 8 | .2m Shower Hose | |
| 9 | Mounting Nut | x1 |
| 10 | Long Screw | x2 |
| 11 | Plastic Anchor | x2 |
| 12 | Teflon Tape | x1 |
| 13 | Allen Key | x1 |
Spare Parts:
14| M5 Screws| x2
15| Spare Rubber Washer For Diverter| x1
16| Spare Rubber Washer For Shower Hose| x2
Instructions
- Working pressure: 0.05-I Mpa, Working temperature: 0-55°C.
- Products are manufactured as per standard AS/NZS 3662:2005. as per Australian standard, and with WaterMark & WELS certificate as shown in the packing.
- All surfaces should be cleaned with water or mild liquid degergent. Do not use cream cleaner or citrus based or chemical cleaning products.
Warranty Terms
All products are guaranteed as below:
- 5 years guarantee against main body,finishing and Cartridge.
- 2 years guarantee on washers and O-rings.
Installation Steps
Unscrew 2 M5 screws and take out the mounting nut from diverter by allen
key.
Plug the diverter onto the mounting nut and
fasten it firmly by 2 M5 crews with allen key.
Put the rubber washer onto the diverter and screw the main pipe by
hand and fasten it firmly by spanner.
Make sure the decoration base screws are loosed enough before
connecting the main pipe for marking drill hole.
Drill one 6mm hole on marked place, put plastic anchor into drilled hole and
fix the decoration base firmly by long screw.
Plug the main pipe into the decoration base and fasten it firmly by 2 M5
screws with allen key.
Adjust the upper pipe hight and angle to proper positon.
Make sure washers as shown into shower hose. Please note that the
conical nut should be connected to shower head, the hex nut should be
connected to the rear outlet of diverter.
Important:
Make sure there are rubber washers inside both end of shower hose. Connect
the diverter front inlet and connector with 1.2m shower hose which is both
side hex nut.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>