Decaura 55705CH Pull Out Sink Mixer Instruction Manual

Installation Manual

Pull Out Sink Mixer

– For Model Code: 55705CH, 55705BK, 57305CH, 57305BK

Please check over carefully the surface and accessories to avoid any damage and missing part.

No.      Description                  Quantity
1.         Pull Out Hose                       x1
2.         Washer                                  x1
3.         Spray Head                            x1
4.         Inlet Hose                             x2
5.         Gravity Ball                           x1
6.         Screw                                    x2
7.         Fixting Nut                           x1
8.         Gasket                                   x1
9.         Washer                                  x1
10.       Quick Lock Connector          x1
11.       Washer                                  x1
12.       Body                                     x1

Instructions

1. Working pressure: 0.05-1 Mpa, Working temperature: 0-55°C.
2. Products are manufactured as per standard AS/NZS 3718:2005, as per Australian standard, and with WaterMark & WELS certificate as shown in the packing.
3. All surfaces should be cleaned with water or mild liquid detergent. Do not use cream cleaner or citrus based or chemical cleaning products.

Warranty Terms

All products are guaranteed as below:

1. 5 years guarantee against main body, finishing and cartridge.
2. 2 years guarantee on washers and O-rings.

Installation Steps

Step 1
Unscrew the fixing nut, stainless steel gasket and rubber washer from the kitchen tap.

Step 2
Cross all hoses through the countertop hole and hold the faucet body.

1. Notice:
   Make sure there is rubber washer inside the tap bottom.

2. Hole diameter:
   32mm(Min)~48mm(Max)

3. Max. countertop thickness:
   45mm(Max)

Step 3
Put the rubber washer, stainless steel gasket and fixing nut through the pull out hose, screw the fixing nut by hand and fasten it, then use a Phillips screwdriver to tighten the two screws until it is stable enough.
Then connect the water inlet hoses to two copper ends in red and blue tightly.

1. Countertop
2. Rubber washer
3. Stainless Steel gasket
4. Fixing nut
5. Water inlet hose
6. Pull-out hose

Step 4
Inset the pull out hose end into the plastic connector. Make Sure the hose is properly engaged and secured in the plastic connector. Fix the gravity ball where the label specified, tightly fasten the tow screws. Then pull out the shower head and release it for several times to check if it is working smoothly. Connect the two water inlet hoses to the angle valve as per red/blue mark.

1. Installation for pull out hose and the Weight ball as shown
2. Weight here
3. Pull out hose
4. Plastic connector

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>