Decaura 8580XCH Wels Twin Hose Shower Instruction Manual
- June 17, 2024
- Decaura
Table of Contents
Decaura 8580XCH Wels Twin Hose Shower
DIMENSION
Rain Shower Set – For Model Code: 8580XCH,8580XBK,8580-2XCH,8580-2XBK (In different shower heads only)
PARTS
Many thanks for purchasing Decaura products, please check over carefully the surface and accessories to avoid any damage and missing parts.
Instructions
- Working pressure: 0.05-1 Mpa, Working temperature: 0-55 °C.
- Products are manufactured as per standard AS/NZS 3662:2005. as per Australian standards, and with WaterMark & WELS certificate as shown in the packing.
- All surfaces should be cleaned with water or mild liquid detergent. Do not use cream cleaner or citrus based or chemical cleaning products.
Warranty
Warranty Terms
All products are guaranteed as below:
- 5-year guarantee against the main body. finishing and Cartridge.
- 2-year guarantee on washers and O-rings.
Installation
Installation Steps
Make sure the decoration base screws on both sides are loosed enough before
connecting the main pipe for marking the drill hole.
Drill one 6mm hole in a marked place, put a plastic anchor into the drilled
hole and fix the decoration base firmly with a long screw. Plug the main pipe
into the decoration base and fasten it firmly by 2 MS screws with alien key.
Unscrew the upper pipe by spanner. Adjust the upper pipe height and angle to a
proper position and screw the upper pipe firmly with a spanner
Important:
Make sure there are rubber washers inside both ends of the shower hose.
Connect the diverter front inlet and connector with I .2m shower hose which is
both side hex nut.