PARADOX REM25 Two Way Wireless Remote Control User Manual

July 23, 2024
Paradox

PARADOX REM25 Two Way Wireless Remote Control

Technical Specifications

  • RF Frequency: 433 MHz / 868 MHz
  • Battery Type: 1 x 3V lithium battery (CR2032) – Battery life expectancy is a minimum of two years.
  • Wireless Range (typical residential environments):
    • 30m (100 ft) with MG6250
    • 45m (150 ft) with MG5000, MG5050, RPT1 and RTX3
  • Humidity: 5 to 90%
  • Dimensions: 3.9 x 7.2 x 1.2 cm (1.5 x 2.8 x 0.5 in.)
  • Certification: CE

Product Usage Instructions

Button Assignment
The REM25 can perform up to six different functions:

  • Arm system
  • Activate/deactivate PGM 1
  • Activate/deactivate PGM 2
  • Disarm system
  • System status

Configuring Button Actions
 Your dealer can modify the button actions using the BabyWare software to associate them with different actions.

REM25 Remote Control Action / Feedback

Action Audible LED Feedback Feedback
ARM button: confirmation Red 5 quick beeps
DISARM button: confirmation Green 2 quick beeps
PGM 1 /2 button: confirmation Orange 5 quick beeps
i button with system armed Red 5 quick beeps
i button with system disarmed Green 2 quick beeps
Fail* Flashing Orange 1 long beep (fast) – Transmission failed or

confirmation not
received.

How to Replace the Battery

  1. Using a screwdriver, remove the screws from the back of the remote control and carefully remove the back cover.
  2. Push the battery out from under the battery plate.
  3. Avoid using metal to prevent short circuits.
  4. Insert the new battery ensuring correct polarity.
  5. Reassemble the remote control by fastening the back cover with screws.

Frequently Asked Questions (FAQ)

  1. Q: How often should I replace the battery?
    A: The battery should be replaced every two years for optimal performance.

  2. Q: Can I modify the button functions myself?
    A: Button functions can be modified by your dealer using BabyWare software.

Introduction
The REM25 is a two-way wireless remote control that allows you to safely arm and disarm your Paradox security system and receive feedback on your actions.

Button Assignment

The REM25 can perform up to six different functions that allow you to control your system. It initiates communication with your Paradox security system, receives acknowledgment confirmation for your requests and provides the current status of your system. Actions include verifying the status of your system, activating programmable outputs (PGMs) such as lights, garage doors, and arming/disarming your system, refer to Figure 1 for details.

Configuring Button Actions
The REM25 buttons are pre-configured as per Figure 1. Your dealer can modify the above buttons by using the BabyWare software to associate them to different actions. For example, re-assign the Arm button from Regular Arm to Stay Arm.

REM25 Remote Control Action / Feedback

The following table provides the supported visual and audio feedbacks for the REM25.

Action LED Feedback Audible Feedback
ARM button: confirmation Red 5 quick beeps
DISARM button: confirmation Green 2 quick beeps
PGM 1 /2 button: confirmation Orange 5 quick beeps
i button with system armed Red 5 quick beeps
i button with system disarmed Green 2 quick beeps
Fail* Flashing Orange
(fast) 1 long beep
  • Transmission failed or confirmation from the panel was not received.

How to Replace the Battery

  1. Using a screwdriver, remove the screws from the back of the remote control and carefully remove the back cover.
    Note: Do not remove or throw away the waterproofing plastic seal from the battery cover.

  2. Push the battery out from under the battery plate (refer to Figure 2). Avoid using metal as it may cause a short in the board.

  3. Insert the new battery. Make sure the positive polarity (+) of the battery is inserted face down (towards the back cover).

  4. Set the back cover in place, and fasten it with the screws.

Note: Danger of explosion exists if the lithium battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer and only use only new battery. Dispose of used batteries according to the manufacturer’s instructions.
This product contains a coin cell battery. If the coin cell battery is swallowed, it can cause severe internal burns in under two hours and can lead to death.

Technical Specifications

RF Frequency 433 MHz / 868 MHz
Battery Type 1 x 3V lithium battery (CR2032)

Battery life expectancy is a minimum of two years.
Wireless Range (typical residential environments)| 30m (100 ft) with MG6250
45m (150 ft) with MG5000, MG5050, RPT1 and RTX3
Humidity| 5 to 90%
Operating Temperature| -10 to 55 ºC (14 to 122 ºF)
Dimensions| 3.9 x 7.2 x 1.2 cm (1.5 x 2.8 x 0.5 in.)
Certification| CE

Warranty
For complete warranty information on this product, please refer to the Limited Warranty Statement is found on the website: www.paradox.com/terms or contact your local distributor. Specifications may change without prior notice.

Patents
US, Canadian and international patents may apply. Paradox is a trademark or registered trademark of Paradox Security Systems (Bahamas) Ltd.

PARADOX.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals