PARADOX NV37MR Wireless Outdoor Indoor Dual Detector Instruction Manual

June 10, 2024
Paradox

NV37MR
Installation Manual

Wireless Outdoor/Indoor Window and Sliding Door Dual Detector with Anti- Masking and Pet Immunity

General Description NV37MR

Thank you for choosing the NV37MR Wireless for your professional protection needs. The NV37MR wireless version will provide you the most advanced window and sliding doors protection either in Pet Immune or Sharp mode. If you have any comments please write to us at Paradox.com/products/feedback.

Recommended Installations (please read)

Outdoor installation permits placements within frames of sliding windows or doors and presumes protection from raindrops. This ensures best catch performance, anti-masking ability, and pet alarm immunity.
Other installations are possible but in outdoor conditions, pet immunity can decrease. Moreover, space near the detector must be clear from obstacles from a distance of 30 to 40 cm (11.8 to 15.7 in.) within its pattern.

Installing the NV37MR

  1.  Remove the front cover – open the Captive screw.PARADOX NV37MR Wireless Outdoor Indoor Dual Detector - cover

  2. Remove the Main Unit: open the two snap-lock mechanisms on each side of the back cover attaching the Main Unit to the back cover, then remove the Main Unit.

  3. Mount the back cover of the NV37MR onto the window frame or wall using screws.
    Note: PLEASE KEEP AT LEAST 4 cm / 1.5 in. clearance from window/shutterPARADOX NV37MR Wireless Outdoor Indoor Dual Detector -
windowAn optional mounting bracket for the NV37MR is available for ordering, part number: SB35.

  4. Attach the Main Unit to the back cover – ensure the locks snap closed.

  5. Insert two AA batteries.

  6. Set the following Detector settings according to requirementsPARADOX NV37MR Wireless Outdoor Indoor Dual Detector - DefaultThe following table displays the Dip Switch settings.
    Table 1: DIP Switch Functionality

Dip Switch
Number| Function| Mode Description
---|---|---
1| LED| ON: LED on (default) OFF: LED off
2| PET Immunity/
SHARP Mode| ON: PET Immunity mode (default) OFF: SHARP mode
3| For future use
4| Anti-mask| ON: On (default) OFF: Off
5| Anti-mask
Sensitivity| ON: High (default) OFF: Low

7. Close the front cover and tighten the captive screw.
Note: Do not obscure the detector’s field of view.
Note: On MG/SP panels, the anti-masking is reported as a tamper.
Tamper recognition must be enabled in panel programming.
On EVO panels, it is reported as anti-masking if it is enabled in  the panel programming.
Testing the NV37MR
Perform a Walk-Test to test successful installation:

  1. Walk slowly across the far end of the detection range.
  2. Ensure detection.
    Walk test mode lasts 5 minutes after the tamper screw is closed.

Learning the NV37MR
For more information on configuring the NV37MR via the panel, refer  to the panel’s respective programming guide.

  1. Enter the appropriate section number.
  2.  To learn the module, loosen the captive screw until the tamper is  pen. After the module is learned, tighten back the captive screw.

Beam Pattern

PARADOX NV37MR Wireless Outdoor Indoor Dual Detector -
BeamPARADOX NV37MR Wireless Outdoor Indoor
Dual Detector - SHARPLED Display

Feature LED Status Indicator
Tamper open Green: ON for 0.3 seconds every 30 seconds
PIR sensitivity level setting Green: Flashes 1-3 times according to the

selected level
Alarm detection| Red: ON for 2 seconds
Power Save mode: Red blinks
Booting/Tamper close| Green/Red alternating flashes for 30 seconds
Anti-mask detection| Flashing Orange:
Pre-mask situation is detected. Orange LED flashes ON/OFF 3 times, every 30 seconds, for as long as anti-mask is detected.

Technical Specifications

Model Number NV37MR
Infrared sensor type 2 dual elements
Detection range •PET Immunity mode: 7.5m x 2m (25 x 7 ft)

•Sharp mode: 10 x 2m (33 x 7 ft)
Super Pet Immunity| Pet size approximately 50 cm
Anti-mask| Active IR detection of blocking objects and liquids sprayed on the detector from a distance of up to 7.5 cm.
Input voltage| 3VDC=2 x1.5VDC AA Alkaline batteries
Current consumption| 40pA in Standby
30mA in Alarm/RF Transmitting
Battery life| 3 years of typical use
Low battery voltage Signal| 2.35V
Compatibility| RTX3 and Magellan systems
Outdoor protection| IP54
Operation temperature| -40°c to +70°c
Relative humidity| 95% non-condensing
Tamper| Dual – Cover and Wall
RF Frequency| 433.92 MHz or 868.35 MHz
Dimensions| 12.3 x 6.1 x 4.3 cm (4.8 x 2.4 x 1.7 in.)
Weight| 100g / 0.2 lb
Certifications| CE, EN50131-2-2 Grade 2, Class IVA EN 50131-6 Type C
Certification Body: Applica Test & Certification
Note: EN performance tests were conducted on sensitivity level 3 (high).

  • Tamper recognition must be enabled on panel programming.

Warranty
For complete warranty information on this product, please refer to the Limited Warranty Statement found on the website: www.paradox.com/terms or contact your local distributor. Specifications may change without prior notice.
Patents
US, Canadian and international patents may apply.
Paradox is a trademark or registered trademark of Paradox Security Systems (Bahamas) Ltd.

NV37MR-EI00 03/2022
PARADOX.COM

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals