paradox DANY64 Swivel Mount Bracket 469 User Manual
- June 5, 2024
- Paradox
Table of Contents
paradox DANY64 Swivel Mount Bracket 469
The new and improved”Swivel Mount” from Paradox enables you to mount and orient a motion detector anywhere on a ceiling or wall surface (fiat/corner mount), ensuring optimal coverage of the protected area. This attractively designed unit can be used with most of the Paradox motion detectors. For detectors that do not fit the Swivel Mount, drill holes in the detector’s plastic back panel to permit mounting.
Installation
- Run wires through the ceiling wall plate (B) and the detector mounting plate (E). Additional wiring can be run through the auxiliary wiring hole (F).
- Insert the shaft (G) of the detector mounting plate into the center hole of the face of the ceiling/ wall plate. Screw together, using the ceiling wall plate nut (A).
- FLAT SURFACE MOUNT: Snap off corner mount flaps (1) and using four screws (not supplied) install (B) on ceiling or wall and screw in tightly.
- CORNER MOUNT: Using four screws (not supplied) install (0) on a comer and screw in tightly.
- Connect the detector.
- Assemble the detector on the detector mounting plate (E), using the two short screws (D) supplied.
- To “fine-tune” the positioning of the detector, adjust the angle of the detector mounting plate’s shaft (G) and lock it in place by tightening the long screws (C)
For corner mount only. For flat surface mounting snap off flaps.
Warranty
For complete warranty information on this product please refer to the Limited Warranty Statement found on the website www.paradox.com/terms. Your use of the Paradox product signifies your acceptance of all warranty terms and conditions. For the latest information on products approvals, such as UL and CE. please visit www.paradox.com 2007 Paradox Security Systems Ltd. All rights reserved. Specifications may change without prior notice. One or more of the following US patents may apply: 7046142, 6215399, 6111256, 6104319, 5920259, 5886632, 5721542, 5287111, 5119069, 5077549 and RE39406 and other pending patents may apply. Canadian and international patents may also apply