ITC ICM-01-F Magnetic Wireless Charger Instruction Manual

ITC ICM-01-F Magnetic Wireless Charger

Product Information

Specifications:

• Product Name: MAXTM Magnetic Wireless Charger
• Part Number: ICM-01-F
• Input Voltage: 10V – 30V DC
• Manufacturer: ITC
• Address: 3030 Corporate Grove Dr. Hudsonville, MI 49426
• Contact: Phone: 616.396.1355 | Website: www.itc-us.com

Product Usage Instructions

Parts / Tools Needed:

• Magnetic Wireless Charger
• Power Drill & Hole Saw
• Marine Grade Splices (not provided)

Installation Instructions:

1. Determine the installation location, ensuring enough space for the mounting nut and drill a 1″ hole.
2. Remove the paper backing, place the charger, and secure it with the provided plastic nut.
3. Wire the system following the provided diagram. Seal the wire ends to prevent water ingress.

Safety/Installation Considerations:

• Ensure proper space for mounting and wiring.
• Seal wire ends to prevent water damage.
• Follow the installation diagram for correct wiring.

FAQ

• Q: Can the charger be used in wet conditions?
  A: The charger is designed for marine use and can withstand wet conditions when installed correctly.

• Q: What is the input voltage range of the charger?
  A: The charger supports an input voltage range of 10V to 30V DC.

PARTS / TOOLS NEEDED

Safety/Installation Considerations

• Electrical Specs:
  Input voltage: 10-30V DC| Charging Capacity: Up to 15W (device limited) | Operating Current: 1.4 @ 13.6V | Standby Current: 0.08A

• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.

• The charger has been designed to work with Qi compatible devices.

• The charger has been designed to charge and operate within the receiving device’s thermal parameters. Low or high temperatures
  might cause the receiving device to change their charging behavior to regulate its temperature and preserve battery life. Typical temperature ranges are 4ºC to 35ºC (40ºF to 95ºF). When exceeding these operating temperatures, the phone and/or the charging device may temporarily stop charging to protect from overheating.

• To prevent damage to the magnetic strip, make sure there are no objects such as credit cards, passports, hotel keys, etc. between the charger and phone before charging.

• This charger has been optimized with no case installed. If a thick phone case is added to the distance between the charger surface/ magnet and the phone, it may cause the magnet to fail, the device to not charge, or the device to temporarily shut down and protect from over-heating.

• A certified MagSafe® charging case or ESR HaloLock™ case is recommended for best magnetic performance. Cases should have magnets or ferrous metal on the back surface of the case. Ferrous metals behind a case or the phone’s magnetic ring alone will not hold properly.

INSTALLATION

1. Determine the installation location, making sure there is enough room to accommodate the mounting nut on the back and drill a 1⅛” hole
2. Remove the paper backing, install the charger and tighten the provided plastic nut.
3. Wire to the system following the diagram below. The ends of the wires should be sealed to prevent water ingress

3030 Corporate Grove Dr. Hudsonville, MI 49426 Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return- policy
DOC #: 710-001718 • Rev A • 05/08/24

References

• ITC Warranty & Return Policy

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>