ritter solida4 Food Slicer Instruction Manual

ritter solida4 Food Slicer Instruction Manual

Operating instructions | Food slicer

1. Stop plate
2. Left-over holder
3. Slice carriage
4. Release button ª)
5. Blade catch b)
6. Blade cover
7. Switch (intermittent/ continuous operation)
8. Power cord
9. Cable compartment
10. Type label
11. Slice tray a)
12. Slice thickness adjustment knob
13. Rotary blade
    a) on model solida⁴ / inteso⁴
    b) Behind blade cover

solida⁴ / inteso⁴

solida⁵ / inteso⁵

GENERAL SAFETY INSTRUCTIONS

To avoid personal injury or dam age to the appliance, please observe the following safety instructions:
– The food slicer is to be used for domestic purposes only and must not be used commercially.
– Never set the appliance down on hot surfaces or close to a naked flame.
– Use the accessories included in the delivery specification only.
– Use suitable extension cables only.
– Do not bend the power cord. Never wrap the cable around the appliance.
– Route the power cord so that it does not come into con tact with hot or sharpedgedobjects.
– Only start to use the appliance after it has been securely set up.
– Persons with reduced physical, sensory or intellectual capabilities or lacking in relevant experience and/or knowledge may only use this appliance if they do so under supervision or have been instructed in the safe use of the appliance and understand the potential risks associated with its use.
– Do not allow children to play
with the appliance.
– Always disconnect the appliance from the mains whenever it is to be left unsupervised, and also prior to assembly, dismantling and cleaning.
– This appliance must not be used by children. Keep the appliance and its connection cable out of reach of children.
– Only connect the appliance to a suitable AC power source that complies with the specifications on the type label.
– Never leave the appliance unattended while it is
operating.
– Do not use it to cut frozen foods, hot foods, bones, food containing large stones, roast meats encased in netting or packaged foods!
– Never allow the appliance to run for more than 5 minutes at a time.

Risk of electric shock

– Always remove the power plug from the socket in the event of a malfunction, before cleaning and when the appliance is not in use. When doing so, pull on the plug and not on the cable.
– Never immerse the appliance in water. Never expose the appliance to rain or any other form of moisture. If the appliance falls into water, unplug the cable from the mains socket before removing the appliance from the water. Have the appliance inspected at an authorized service location before using it again.
– Always ensure that your hands are completely dry before using the appliance. Do not use the appliance if it is wet or damp or while you are standing on a damp surface. Do not use the appliance outdoors.
– Stop using the appliance immediately if any parts are damaged and contact the ritter aftersales service.
– If the power cord is damaged, it must be replaced by the manufacturer, the manufacturer’s aftersales service or a similarly qualified person to eliminate risk of personal injury.

Risk of injury

– This appliance must not be used without a slice carriage or a leftover holder, unless the size and shape of the food to be sliced means that these parts cannot be used.
– Before replacing accessories or addon parts that move when operated, the appliance must be switched off and dis connected from the mains.
– The rotary blade is extremely sharp.
– Never touch the rotating blade when operating the appliance!
– Switch the appliance off before cleaning it; pull the power plug out of the socket and turn the slice thickness adjustment knob to the “0” position.
– The rotary blade will continue to run for a short time after being switched off.

Unfold the illustrations at the front and back of this manual.

Please read these instructions thoroughly before you start to use the appliance. Keep these operating instructions in a safe place and ensure that they are included with the appliance if passing it on to a third party.
Alternatively, the current operating instructions are available at www.ritterwerk.de.

INTENDED USE

The food slicer is used for the slicing of household foods.
The food slicer is suitable for contact with foodstuffs.
If the appliance is used for a purpose other than this, or if it is operated incorrectly, severe injuries may occur or the appliance may be damaged. All warranty and liability claims will be rendered null and void in this case.

BEFORE USING THE APPLIANCE FOR THE FIRST TIME

Preparation

Remove the appliance carefully from the packaging. Remove all packaging components and keep them in a safe place along with the packaging itself. Clean the appliance before allowing it to come into contact with any food (see CLEANING).

Setting up the appliance

• Set the appliance down on a flat, nonskid surface close to a mains socket.
  A solida⁴ / inteso⁴
  Slide the slice carriage (3) into the guide grooves on the appliance.
  A sono⁵ / sinus⁵
  Using a small amount of force, push the slice carriage (3) vertically into the guide groove on the appliance until it audibly locks into place.
  B Slide the leftover holder (2) onto the slice carriage’s handle.
  C Unwind the power cord (8) to the length required from the cable compartment (9) under the appliance.

• Plug the cable into the socket.

SLICING

D Use the slice thickness adjustment knob (12) to set the required thickness.

Info:
The slice thickness adjustment scale is not a millimetre scale. For safety reasons, the “0” position is designed to cover the blade.
E Place the food to be sliced onto the slice carriage (3). Use the leftover holder (2) to press it up against the stop plate (1).
F Protect your hands by always using the slice carriage and, where applicable, the leftover holder.
Exception: Excessively large foods to be sliced.
• Turn the appliance on using the switch (7). Two operating modes are available:

Intermittent operation (Position II):
The rotary blade (13) runs as long as the switch is pressed and held down in this position.

Continuous operation (Position I):
The rotary blade runs without the switch being pressed and held down until you move the switch to the “0” position.

Info:
Never use the appliance for more than a maximum of 5 minutes in continuous operation.
• With the appliance running, gently feed the food to be sliced into the path of the rotary blade.
• When finished slicing, wait until the rotary blade has come to a complete stop.
• After each use, turn the slice thickness adjustment knob to the “0” position, in order to cover up the sharp rotating blade and to avoid any injuries.

CLEANING

Caution:
Switch the appliance off before cleaning it; pull the power plug out off the socket and turn the slice thickness adjustment knob (12) to the “0” position.

Clean the food slicer regularly to prevent the accumulation of food residue. The rotary blade must also be cleaned regularly as described below to prevent its surface from rusting.

Info:
Over time, an accumulation of food residue may cause damage to the surface of the rotary blade, causing it to rust.

Preparation

solida⁴ / inteso⁴
• Pull the slice tray (11) to the left and out of the appliance.
• Removing the leftover holder (2).
G solida⁴ / inteso⁴
Press the release button (4) and pull the slice carriage (3) off the appliance.
G sono⁵ / sinus⁵
Pull the slice carriage (3) towards you and then lift it up and out of the guide groove
Removing the rotary blade:
H Remove the blade cover (6).
I Open the blade catch (5), by turning it in a clockwise direction.
• Remove the blade catch.
• Take hold of the rotary blade (13) at its rotational centre and remove it.

Cleaning after each use
• Wipe down the housing and all removed parts, including the rotary blade, with a damp cloth.

Occasional cleaning
• Give all removed parts, including the rotary blade, a thorough wash in warm soapy water (not in the dishwasher!).
• Clean the housing behind the blade using a dry cloth/brush.
Info:
Do not use any abrasive cleans-ers, sponges with rough surfaces or hard brushes.
• Dry all parts that you have washed.
• Grease the rotary blade’s gear wheel with a little ritter maintenance grease (alternatively with a little Vaseline).

Assembling the appliance
• Carefully insert the rotary blade.
• Insert the blade catch.
• Close the blade catch by turning it in an anticlockwise direction.
• Mount the blade cover.
A solida⁴ / inteso⁴
Slide the slice carriage (3) into the guide grooves on the appliance.
A sono⁵ / sinus⁵
Using a small amount of force, push the slice carriage (3) vertically into the guide groove on the appliance until it audibly locks into place.

MAINTENANCE

Your food slicer is maintenance free. However, we recommend that you occasionally apply a little extra ritter maintenance grease or Vaseline to the rails of the slice carriage to keep them lubricated and ensure that the carriage continues to move easily.

STORAGE

Keep the appliance out of the reach of children.
To store the cable, always use the cable compartment integrated into the appliance.

DISPOSAL OF WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT

This symbol indicates that this product must not be disposed of with unsorted municipal waste. There is a separate (free) system for the collection and return of waste electrical and electronic equipment. For more information, please contact your local authority or the shop where you purchased the product. By ensuring that this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health and contribute to the conservation of natural resources.

REACH DIRECTIVE
See www.ritterwerk.de

SPECIAL ACCESSORIES

A special, nontoothed rotary blade is also available for use with sliced meat, sausage and ham.
The original ritter maintenance grease is available for delivery for maintaining (regreasing) the food slicer.

EXPLANATION OF SYMBOLS

SERVICE, REPAIRS AND SPARE PARTS

Please contact your local after sales service for all service, repairs and spare parts issues. See www.ritterwerk.de

TECHNICAL DATA

The appliance complies with the CE specifications.
Mains voltage/power consumption: Refer to the type label on the underside of the appliance.
Slice thickness: 0 mm to approx. 23 mm

WARRANTY

This ritter appliance comes with a two year manufacturer’s warranty, starting with the date of purchase and in accordance with the EU warranty directives. Your legal warranty claims according to § 437 ff. BGB (German Civil Code) remain unaffected by this regulation. The manufacturer warranty applies to all devices sold within the European Union. For details of the warranty conditions, see www.ritterwerk.de/warranty. In the event of a warranty claim or for servicing, the appliance must always be sent to the appropriate national customer service centre.

ritterwerk GmbH Zentralkundendienst Industriestraße 13 82194 Gröbenzell

Telefon (08142) 440 16-60
Telefax (08142) 440 16-70

kundendienst@ritterwerk.de
www.ritterwerk.de
www.ritterwerk.de/follow-us

References

• Küchengeräte und Haushaltsgeräte „made in Germany“ - ritter
• Küchengeräte und Haushaltsgeräte „made in Germany“ - ritter
• follow-us

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>