Interiors 1900 SN01P43 Semi Flush Light Instruction Manual
- June 3, 2024
- Interiors 1900
Table of Contents
Installation and Safety Instructions
Semi Flush Light Fitting
Safety Warnings
These instructions are for your safety. Please read through them thoroughly
before use and retain them for future reference. If you are in any doubt about
installing this product, consult a qualified electrician. This product is only
suitable for connection to a 220-240V~ 50Hz supply in accordance with current
IEE wiring regulations, and should be installed in accordance with local
building regulations. It is for domestic ceiling use only, and is not suitable
for a bathroom location.
This is a Class l product and must be Earthed. The terminal blocks are
supplied according to requirements of the fitting.
IMPORTANT: Always switch off the mains supply during installation or
maintenance. We recommend that the fuse is withdrawn or the circuit breaker
switched off at the distribution board whilst work is in progress (turning off
the light switch is not sufficient). Connection should be via a wall switch to
nable safe isolation. The product must be securely fixed to the mounting
surface using the screws and wall plugs supplied. The screws and wall plugs
supplied are suitable for “masonry” only. Other fixings are not supplied and
must be purchased. Decide on the position of the light fitting or remove
existing light fitting.
Note the position of the electrical connections, and ensure there is a solid
mounting surface, Preferably a wooden joist or joist bridge, to support the
weight of the light fitting.
Take care not to drill into any pipes or mains cables beneath the surface
during mounting holes preparation.
Never put anything on the product or hang anything on any part of this
product.
IMPORTANT: Ensure that all electrical connections are tight and that no
loose strands are left out of the terminal.
Never fit bulbs of a higher wattage than those specified on the label (as
these may cause over heating and damage the fitting).
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product (preferably, isolate it at the
distribution board) and allow it to cool down (Caution: bulb gets hot during
use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this
product.
Troubleshooting
When the bulb does not light after installation:
Ensure there is no electricity failure.
Ensure all the connections are secure.
If you have any doubt about installation/use of this product, consult a qualified electrician.
Assembly Instructions
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
SN01P43-01P63-02P47-03P46-04P50_05022022
Scan QR code for multi-language
https://qrco.de/bbiq6g
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>