Interiors 1900 69832 Winchester Picture Light Instruction Manual

June 3, 2024
Interiors 1900

Interiors 1900 69832 Winchester Picture Light

Interiors-1900-69832-Winchester-Picture-Light-product

Safety Warnings

These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply in accordance with current IEE wiring regulations, and should be installed in accordance with local building regulations. It is for indoor use only, and is not suitable for a bathroom location.
This is a Class l product and must be Earthed. The terminal blocks are supplied according to requirements of the fitting.

IMPORTANT: Always switch off the mains supply during installation or maintenance. We recommend that the fuse is withdrawn or the circuit breaker switched off at the distribution board whilst work is in progress (turning off the light switch is not sufficient). Connection should be via a wall switch to enable safe isolation.
The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only. Other fixings are not supplied and must be purchased.
Decide on the position of the light fitting or remove existing light fitting. Note the position of the electrical connections, and ensure there is a solid mounting surface, Preferably a wooden joist or joist bridge, to support the weight of the light fitting.
Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
Never put anything on the product or hang anything on any part of this product.

IMPORTANT: Ensure that all electrical connections are tight and that no loose strands are left out of the terminal.

Never fit bulbs of a higher wattage than those specified on the label (as these may cause over heating and damage the fitting).
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.

Care and maintenance

For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Troubleshooting

When the bulb does not light after installation:

  • Ensure there is no electricity failure.
  • Ensure all the connections are secure.

If you have any doubt about installation/use of this product, consult a qualified electrician

Assembly Instructions

Interiors-1900-69832-Winchester-Picture-Light-
fig-1

  1. Decide on the position of the light fitting, or remove existing light fitting. Note the position of the electrical connections.
  2. Use the wall cup (1) as a template to mark and make the screw holes.
  3. Support your fitting and connect the house wiring to the terminal block (2).
  4. Slot the screws (3) through the front of the wall cup and attach the fitting to the wall. Place the decorative caps (4) over the screw ends
  5. Fit the appropriate bulbs (sold separately).
  6. Turn on and test that the light illuminates.
  7. To adjust the lamp arm and head, switch off and wait at least 10 minutes for the fitting to cool. Loosen the handles and move one section at a time into the desired position, then retighten the handles. Ensure the fitting has been supported through the whole process

UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals