Ledvion LVS101I4 Ultra Bright 8W 850LM Solar LED Wall Light With Sensor User Guide
- July 17, 2024
- Ledvion
Table of Contents
Ledvion LVS101I4 Ultra Bright 8W 850LM Solar LED Wall Light With Sensor
User Guide
Specification
Product Name | Solar LED Wall Light with Sensor |
---|---|
Power | BW |
Brightness | BSOLM |
Lamp Dimension. | 232.0*22061214mm |
LEDS | SMD2835 104PCS (Front 102PCS Back 2PCS) |
Li-ion Battery | 18650, 3.7V, 4000mAh, 14.8Wh (Replaceable) |
Solar Panel | 4.4W, DC5.5V, Mano with tempered glass |
Working Modes | Two Optional Working Modes |
Charging Time | 12-15hrs to fully charge |
Lighting Time | Sensor Mode: 35hrs+ (based on 300 times of detections) Keep |
Lighting Mode: 30hrs+ (based on 200 times of detections)
PIR Detection Angle/Distance| 120/2-6Mtrs
IP Degree| IP65 Waterproof
Housing Material| ABS+PC anti-UV
Installation Height| 2-4Ms
Working Temperature| -20-50°C
Storage Temperature| 0-45°C
Warranty| 24 months (battery 12 months warranty)
Packing| Colorbox (1 Solar Light, 1″Accessory Bag. 1 Measure Card, 1″User
Manual)
Top Features
-
Front & Back Light
-
Two Optional Lighting Modes
-
Zero Electricity Bills
-
Solar Powered
-
Long Lighting Time
-
PIR Detective
-
Auto On/Off
-
Safe
-
Cordless to Install
-
Ultra Bright
-
IP65 Waterproof
-
Battery Replaceable
installation
The recommended installation height is 2-4 meters.
- Please use measure card to mark holing positions and drill 3 holes of $6mm.
- Install 3 expansion plugs into the holes.
- Install 3 screws in the expansion plugs, allow the screws to protrude slightly.
- Align the lower notch on the back of the light with the lower screw and align the holes at the top of the light with the upper screws to fix the light well.
- Press the button on the back of the light to turn on the light and select desired working mode.
packing content
-
1*Solar Light
-
1*Measure Card
-
1* Accessory Bag
-
1*User Manual
Two Optional Working Modes
Mode A: Sensor Mode
Press the button 1st time, the back light flashes once, it’s Sensor Mode:
When battery power is greater than 30%:
Lamp autornatically lights up at night and turns to full brightness when
motion is detected within the range of ≤6mtrs, then dims to lower
brightness(front light and back light both on) after 20 seconds of no motion.
When battery power is less than 30%:
Lamp automatically lights up at night and turns to full brightness when motion
is detected within the range of ≤6mtrs, then dims to lower brightness(front
light off, only back light on). after 20 seconds of no motion.
Mode B: Keep Lighting Mode
**Press the button 2nd time, the back light flashes twice, it’s Keep Lighting
Mode:
**
Lamp automatically lights up at dusk and remains 50% brightness After 5 hours or when the battery power is less than 30%, it turns to energy saving mode, which is lamp automatically turns to 50% brightness when motion is detected within the range of ≤6mtrs, then dims to lower brightness(front light off, only back light on) after 20 seconds of no motion.
Mode C: Off
Press the button 3rd time, lamp turns off.
Wide Applications
✔ Garden
✔ Pathway
✔ Parking Lot
✔ Holiday Resort
✔ School
✔ Scenic Area
✔ Square
✓ Villa
✔ Entrance
✔ Fence
✔ Courtyard
✔ Balcony
✓ Garage
✓ Swimming Pool
✓ Stairs
✔ Farm
✔ Pavilion
✔ Gate
✔ Community Area
✔ Patio
✔ Hotel
How to replace battery?
-
Loosen the screws, open battery cover,
-
Remove old battery, change new battery and connect positive and negative electrode correctly. (2PCS Battery 18650, 3.7V, 2000mAh, 7.4Wh).
-
Then install back the cover, lock the screws.
Warnings
-
This is a solar powered lamp, please install it in a location where can get enough sunshine.
-
Please note the lighting time depends on sunshine duration & weather & working mode.
-
The lamp will light up automatically at dusk.
-
Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection, safe and durable.
-
The lamp is equipped with internal Li-ion batteries, which are replaceable.
If any need, please contact seller for new battery(18650, 3.7V, 2000mAh, 7.4Wh). -
If the battery is taken out and put back in or replaced with new ones, please toward the solar panel to sunshine or a strong light to activate the lamp.
-
Non-professionals please do not disassemble the lamp.
-
Please do not dispose the battery with household garbage to avoid explosion.
Please follow all instructions to operate.
Save this manual for future reference.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>