SHARP SPC476 AccuSet Digital Alarm Clock User Manual
- July 12, 2024
- Sharp
Table of Contents
- SHARP SPC476 AccuSet Digital Alarm Clock User Manual
- Controls
- Setting Procedure For The AccuSet™ Clock
- Setting The Alarm
- Using The Alarm Function
- Snooze Function
- Dimmer Function
- Manual Time Set Function
- Time Reset
- Care For Your Clock
- Replace The AccuSet™ Clock Battery
- Digital Alarm Clock
- FCC Information
- Safety Instructions
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SHARP SPC476 AccuSet Digital Alarm Clock User Manual
Thank you for your purchase of this quality clock. The utmost care has gone into the design and manufacture of your clock. Please read these instructions and store them in a safe place for future reference.
Controls
- PM INDICATOR
- ALARM INDICATOR
- ALARM BUTTON
- TIME BUTTON
- DIMMER HI/LO SWITCH
- SNOOZE BUTTON
- RESET BUTTON
- DST ON/OFF SWITCH
- TIME ZONE SWITCH: EST=EASTERN, CST=CENTRAL, MST=MOUNTAIN, PST=PACIFIC
- BATTERY COMPARTMENT
- HOUR BUTTON
- MINUTE BUTTON
- ALARM ON/OFF SWITCH
Setting Procedure For The AccuSet™ Clock
Before plugging in the power cord into a standard household outlet.
- Slide the TIME ZONE switch to the correct time zone.
- Slide the DST switch to the appropriate position for your area.
- Once all above is completed, plug in the power cord into a standard household outlet.
- The clock will fast forward to the correct time.
Setting The Alarm
- Press and hold the ALARM button down to activate alarm setting.
- While holding down the ALARM button, press the HOUR button to advance to the correct hour. The PM indicator will light when the hour is advanced into the PM time.
- While holding down the ALARM button, press the MIN button to advance to the correct minute.
- Release the ALARM button when the correct alarm time is shown on the display.
Using The Alarm Function
- Slide the ALARM ON/OFF switch to ON position to activate the alarm and the alarm indicator will be lit.
- Slide the ALARM ON/OFF switch to OFF position to deactivate the alarm and the alarm indicator no longer be visible.
Snooze Function
Pressing the SNOOZE button after the alarm sounds will cause the alarm to pauseand the alarm will sound again in 9 minutes. This will happen each time the SNOOZE button is pressed.
Dimmer Function
To adjust the display brightness, slide the DIMMER HI/LO switch to select between Hi or Lo brightness level.
Manual Time Set Function
- Press and hold the TIME button down to activate time setting.
- While holding down the TIME button, press the HOUR button to advance to the correct hour.
- The PM indicator will light when the hour is advanced into the PM time.
- While holding down the TIME button, press the MIN button to advance to the correct minute.
- Release the TIME button when the correct alarm time is shown on the display.
Time Reset
To reset the clock use a paper clip to press the RESET button at the bottom of theclock. The clock will reset to the default time of 12:00. The time and alarm willneed to be set manually.
Battery Precautions
- Only batteries of the same or equivalent type are to be used.
- Batteries are to be inserted with the correct polarity.
- The supply terminals are not to be short- circuited.
- Exhausted batteries are to be removed from the product.
- Do not dispose of batteries in fire; batteries may explode or leak.
- Adult assembly required to replace and remove battery.
Care For Your Clock
The batteries should be replaced if the display or alarm becomes weak or dysfunctional. Store the clock without batteries when not in use. A soft cloth or apaper towel may be used to clean your clock. Do not use any corrosive cleaner orchemical solution on the clock. Keep the clock clean and dry to avoid problems.
Replace The AccuSet™ Clock Battery
- AccuSet™ is powered by a pre-installed button-cell battery that stores the time and date settings. The battery has a shelf life of several years. To replace the AccuSet™ battery:
- Locate the button-cell battery compartment door on the bottom of the clock. Unscrew and remove the compartment cover.
- Insert 1 x CR2032 button-cell battery into the battery compartment. Install battery with “+” positive terminal facing OUT.
- Screw in the battery cover.
WARNING
This product contains a button-cell battery in a screw secured compartment. If
swallowed, it could cause severe injury or death in just 2 hours. Seek medical
attention immediately if ingested.
Digital Alarm Clock
This lightning flash and arrowhead within the triangle is a warning signaling you of “dangerous voltage” inside the product.
CAUTION
- RISK OF ELECTRIC SHOCK DO NOT OPEN
- TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (ON BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The exclamation point within the triangle is a warning sign alerting you of important instructions accompanying the product.
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION : TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
Please read this before operating your unit.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Caution : Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Safety Instructions
- Read these instructions – All the safety and operating instructions should be read before this product is operated.
- Keep these instructions – The safety and operating instructions should be retained for future reference.
- Heed all warnings – All warnings on the appliance and in the operating instructions should be adhered to.
- Follow all instructions – All operating and use instructions should be followed.
- Do not use this apparatus near water – The appliance should not be used near water or moisture – for example, in a wet basement or near a swimming pool, and the like.
- Clean only with a dry cloth.
- Do not block any ventilation openings, Install in accordance with the manufacturer’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for the replacement of the obsolete outlet.
- Protect the power cord from being walked on or pinched particularly at the plugs, convenience receptacles, and at the point where they exit from the apparatus.
- Only use attachments/accessories specified by the manufacturer.
- Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart or rack is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
- Unplug the apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualified personnel. Servicing is required when the apparatus has been damaged in any way, such as a power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
- Please keep the unit in a good ventilation environment.
- CAUTION : These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.
WARNING:
- The mains plug is used as a disconnect device, the disconnect device shall remain readily operable. This equipment is a Class Il or double-insulated electrical appliance. It has been designed in such a way that it does not require a safety connection to electrical earth. Do not install this equipment in a confined or building-in space such as a bookcase or similar unit, and remain a good ventilation condition. The ventilation should not be impeded by covering the ventilation openings with items such as newspapers, tablecloths, curtains, etc.
- All the above markings were located on the external enclosure of the apparatus, except for the label of Date Code was pasted inside the battery compartment. The apparatus shall not be exposed to dripping or splashing and objects filled with liquids, such as vases, shall not be placed on the apparatus.
Caution : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
WARNING : The battery shall not be exposed to excessive heat such as sunshine, fire, or the like.
Download pdf:SHARP SPC476 AccuSet Digital Alarm Clock User Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>