CONDTROL ULR Receiver User Manual

CONDTROL ULR Receiver

Congratulations on your purchase of universal line receiver ULR CONDTROL. Safety instructions can be found in the end of this user manual and should be carefully read before you use the device for the first time

SAFETY REGULATIONS

The user manual should be read carefully before you use the device for the first time. Unintended use of the device can be dangerous for human’s health and cause serious injury. Keep this user manual. If the device is given to somebody for temporary use, be sure to enclose user manual to it.

• Do not misuse the device.
• Store the product beyond reach of children and unauthorized people.
• It is prohibited to disassemble or repair the product yourself. Entrust product repair to qualified personnel and use original spare parts only.
• Do not use the product in explosive environment, close to flammable materials.
• Avoid heating the battery to avoid the risk of explosion and electrolyte leakage. In case of liquid contact with skin, wash it immediately with soap and water. In case of contact with eyes, flush with clean water during 10 minutes and consult the doctor.

INTENDED USE

ULR CONDTROL is a multi-frequency line receiver designed to increase the working range of laser levels with red and green beam. 2 working surfaces make operation more convenient both indoors and outdoors. With this receiver the user can take readings on the target scale, which is on the back side of the receiver or follow the LEDs on the front side of the housing. Magnets inbuilt in the housing make it possible to fix the receiver on a ceiling profile or a vertical structure for easy and quick level adjustment

1. Bubble level
2. LED indicators
3. Photocell
4. Magnets
5. Target
6. Power on/off
7. Audio signal on/off
8. Battery cover

DELIVERY PACKAGE

• Universal line receiver – 1 pc.
• Mount of fixing on a leveling staff – 1 pc.
• Batteries (1.5V AAA LR03) – 2 pcs.
• User manual – 1 pc.

TECHNICAL SPECIFICATIONS

INSTALL/REPLACE BATTERIES

Use a screwdriver to loosen the screw of the battery cover and remove it. Install the batteries, observing the polarity. Replace the battery cover and use a screwdriver to tighten the screw. Use alkaline batteries only. Both batteries must be of the same brand, with the same charge level.

OPERATION

In bright light, when it is hard to see the laser line, it is reasonable to use universal line receiver. Press to switch on the receiver. Press to switch on/off audio signal. Bring the receiver to the intended place of location of the laser line. As soon as the laser line hits the photocell, the receiver emits audio signal, one of the LEDs lights up, indicating the direction of movement of the receiver to catch the laser line. Move the receiver until you hear a continuous audio signal and the central LED lights up. Check the alignment of the receiver housing by the bubble level and make a mark on the surface or remember the result of the height if the receiver is fixed on a leveling staff.

CARE AND MAINTETANCE

Attention! Laser receiver is a precise device and requires careful handling. Maintenance of the following recommendations will extend the life of the device:

• Store the product, spare parts and its accessories beyond reach of children and unauthorized people.
• Keep the product clean and protected from any bumps, dust and dampness; do not allow moisture, dust or other dirt get inside of the product.
• If moisture goes into the product, remove the battery and take it to the service center.
• Do not keep or use the device for a long time at high humidity conditions.
• To clean the product use a soft wet cloth. Do not use harsh chemicals, cleaning solvents or detergents.

Mishandling of the following rules can cause electrolyte leakage from the batteries or other damages:

• Remove the battery from the product if you do not use it for a long time.
• Do not leave discharged battery in the laser level

UTILIZATION

Expired tools, accessories and package should be passed for waste recycle. Please send the product to the following address for proper recycle: CONDTROL GmbH Wasserburger Strasse 9 84427 Sankt Wolfgang Germany Do not throw the product in municipal waste! According to European directive 2002/96/ЕC expired measuring tools and their components must be collected separately and submitted to environmentally friendly recycle of wastes

WARRANTY

All CONDTROL GmbH products go through post-production control and are governed
by the following warranty terms. The buyer’s right to claim about defects and general
provisions of the current legislation do not expire.

1. CONDTROL GmbH agrees to eliminate all defects in the product, discovered while warranty period, that represent the defect in material or workmanship in full volume and at its own expense.
2. The warranty period is 24 months and starts from the date of purchase by end customer (see the original supporting document).
3. The warranty doesn’t cover defects resulting from wear and tear or improper use, malfunction of the product caused by failure to observe the instructions of this user manual, untimely maintenance and service and insufficient care, the use of non-original accessories and spare parts. Modifications in design of the product relieve the seller from responsibility for warranty works. The warranty does not cover cosmetic damage, that doesn’t hinder normal operation of the product.
4. CONDTROL GmbH reserves the right to decide on replacement or repair of the device.
5. Other claims not mentioned above, are not covered by the warranty.
6. After holding warranty works by CONDTROL GmbH warranty period is not renewed or extended.
7. CONDTROL GmbH is not liable for loss of profit or inconvenience associated with a defect of the device, rental cost of alternative equipment for the period of repair.

This warranty applies to German law except provision of the United Nations Convention on contracts for the international sale of goods (CISG). In warranty case please return the product to retail seller or send it with description of defect to the following address: CONDTROL GmbH Wasserburger Strasse 9 84427 Sankt Wolfgang Germany

References

• Интернет магазин производителя лазерных измерительных приборов Condtrol

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>