PHILIPS BDS650 Metronomis LED Torch Instruction Manual
- July 13, 2024
- Philips
Table of Contents
PHILIPS BDS650 Metronomis LED Torch Instruction Manual
Disconnect before servicing
This product contains a light source of energy efficiency class: see table or
label. Luminaire has basic insulation between Low Voltage supply and control
conductors. Storage, in stellation, use, operation and maintenance of the
products needs to be performed exactly according the instructions in this
manual
and/or other instructions as may be provided by us to guarantee safe use of
the product over its entire lifetime. Failure to adhere to these instructions
will invalidate your entitlement to warranty. Bolts with indication of torque
strength on the drawing need to be tightened using a calibrated torque wrench.
Preassembled bolts need to be retightened again to the required torque
specification to assure maximum strength over lifetime. The light source
and/or control gear and/or the external flexible cable contained in this
luminaire shall only be replaced by the manufacturer or his service agent or a
similar qualified person. The luminaire should be positioned so that prolonged
staring into the luminaire at a distance closer than 25cm is not expected.
Zhaga-D4i and SR certified compatibility- For Zhaga-D4i/SR-Certified based
luminaires only Zhaga-D4i/SR-Certified components/sensors are to be used (see
also: https://www.zhagastandard.org/products/
https://www.Iighting.phiIips.co.uk/oem-emea/products/driving-con nected-
1ighting). The functional compatibility of two SR-certified and/or
Zhaga-D4i controllers/sensors to be used in combination, as well as the
override possibility of any line-switch function used in an SR-based/Zhaga-D4i
luminaire, is to be released by the master controller/sensor supplier. If
using a NEMA 7-pin socket on an SR-based luminaire, a full system verification
is required. Not following this advice can/will cause risk of damage and non-
compliance for which Signify cannot take any responsibility.
© 2024 Signify Holding
All rights reserved. Reproduction in whole or in part is prohibited without
the prior written consent of the copyright owner.
The information presented in this document does not form part of any quotation
or contract, is believed to be accurate and
reliable and may be changed without notice. No liability will be accepted by
the publisher for any consequence of its use.
Publication thereof does not convey nor imply any license under patent- or
other industrial or intellectual property rights.
Signify Holding
The Netherlands
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>