vtech 10034451 Sew and Style Kitty Bag Instruction Manual

vtech 10034451 Sew and Style Kitty Bag

Specifications

• Touch Sensor
• Motion Sensor
• Mode Switch: Lights Mode, Music Mode, Motion Mode
• Off-On Switch
• Requires 2 AA (AM-3/LR6) batteries (not included)

Product Usage Instructions

Getting Started

1. Ensure the unit is turned off.
2. Locate the battery box at the bottom of the bag.
3. Use a screwdriver to loosen the screw and open the battery cover.
4. If there are used batteries, remove them.
5. Install 2 new AA batteries following the diagram inside the battery box.
6. Replace the battery cover and tighten the screw.

Care & Maintenance

1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Avoid direct sunlight and heat sources.
3. Remove batteries if not in use for an extended period.
4. Avoid dropping the unit on hard surfaces or exposing it to moisture.
5. If the unit stops working, install a new set of batteries.

Troubleshooting

1. Turn the unit off.
2. Remove the batteries to interrupt the power supply.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit on. It should be ready to use again.
5. If the unit still does not work, install a new set of batteries.

Learning Procedure

VTech understands that a child’s needs and abilities change as they grow and with that in mind we develop our toys to teach and entertain at just the right level …

INTRODUCTION

Thank you for purchasing the Sew & Style Kitty Bag!

INCLUDED IN THE PACKAGE

• Sew & Style Kitty Bag
• Guidebook
• Quick Start Guide

WARNING

All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties and packaging screws are not part of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.

PRODUCT FEATURES

1. Mode Switch (Lights Mode – Music Mode – Motion Mode) Slide to Lights Mode to enjoy magical light patterns.
   Slide to Music Mode to listen to fun songs.
   Slide to Motion Mode to jam with the sound effects.

2. Motion Sensor
   Shake the bag to jam with the sound effects.
   No response in Lights Mode and Music Mode.

3. Touch Sensor
   Touch to change the Light/Song.

4. On-Off Switch
   Slide to switch the power on or off.

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.

2. Open the bag and locate the battery box at the bottom. Use a screwdriver to loosen the screw and then open the battery cover.

3. If used batteries are present, removeBthese batteries from the unit by pulling them up on one end of each battery.

4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)

5. Replace the battery cover and tighten the screw to secure it.

WARNING

Adult assembly is required for battery installation. Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
•  Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in a fire.

RECHARGEABLE BATTERIES

• Remove rechargeable batteries (if removable) from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

Disposal of batteries and product

The crossed-out wheelie bin symbols on products and batteries, or their respective packaging, indicate they must not be disposed of in domestic waste as they contain substances that can be damaging to the environment and human health.
The chemical symbols Hg, Cd, or Pb, where marked, indicate that the battery contains more than the specified value of mercury (Hg), cadmium (Cd) or lead (Pb) set out in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the market after 13th August 2005.
Please dispose of your product and batteries responsibly.

In the UK, give this toy a second life by disposing of it at a small electrical collection point* so all of its materials can be recycled.
Learn more at:
www.vtech.co.uk/recycle
www.vtech.com.au/sustainability
Visit www.recyclenow.com to see a list of collection points near you.

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat sources.
3. Remove the batteries if the unit will not be in use for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.
5. If the unit stops working or malfunctions, install a new set of batteries.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.

FAQ

Q: What type of batteries does the product require?

A: The product requires 2 AA (AM-3/LR6) batteries for operation. Alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended for best performance.

Q: How do I dispose of the batteries?

A: For disposal of batteries and the product, please visit www.recyclenow.com to find collection points near you for proper disposal.

References

• Support : VTech Electronics

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>