GE Profile P4AAKASSW Series Opal Side Tank Owner’s Manual

July 9, 2024
GE Profile

GE Profile P4AAKASSW Series Opal Side Tank

Product Information

The Opal Side Tank is a GE Appliances accessory designed to enhance your appliance’s functionality by providing additional storage for water or other liquids.

Specifications

  • Model: P4AAKASSWBB
  • Serial Numbers: P4AAKASSWOW, P4AAKASSWSS
  • Trademark: GE
  • Manufacturer: General Electric Company
  • Trademark License: Yes

Write the model and serial numbers here:

Model # _____

Serial # _____

Find these numbers on a label on the back of the unit.

GE is a trademark of the General Electric Company. Manufactured under trademark license.

49-9000070 Rev. 0 05-24

Thank You

Thank you for making GE Appliances a part of your home.

Whether you grew up with GE Appliances, or this is your first, we’re happy to have you in the family. We take pride in the craftsmanship, innovation, and design that goes into every GE Appliances product, and we think you will too. Among other things, registration of your appliance ensures that we can deliver important product information and warranty details when you need them.

The Good Ice™

Important Safety Information

Read all instructions before using the appliance.

WARNING

  • Do not, under any circumstances, alter or remove the third (ground) prong from the power cord. For personal safety, this product must be properly grounded.
  • Do not exceed power outlet ratings. It is recommended that the ice maker is connected to its own circuit. Use only a 115 V, 60 Hz standard electrical supply that is properly grounded in accordance with the National Electric Code and local codes and ordinances.
  • Due to potential safety hazards under certain conditions, we strongly advise against the use of an extension cord. However, if you must use an extension cord, it is absolutely necessary that it is a UL-listed, 3-wire ground type appliance extension cord having a grounding type plug and that the electrical rating of the cord be 15 Amperes (minimum) and 120 Volts.
  • This product must be properly installed and located in accordance with the installation instructions before it is used. Product is for indoor household use only. Do not use outdoors.
  • Do not store or use flammable vapors or liquids near this product.
  • Do not allow children to climb, stand, or hang on the ice maker. They could seriously injure themselves.
  • Do not look directly at UV lamp when it is operating. The light emitted by the lamp will cause serious eye damage and burn unprotected skin.
  • In order to avoid exposure to UV radiation, disconnect power to the ice maker before removing the external covers.
  • Do not use with water that is microbiologically unsafe or of unknown quality.
  • Place power cord in such a way it cannot be pulled on by children or cause a tripping hazard.
  • Place power cord in such a way that it is not in contact with hot surfaces.
  • Do not operate if any component, including the cord or plug, is damaged.
  • Unplug the product before cleaning by hand and when not in use.
  • Do not immerse any part of the product in water.
  • Do not plug or unplug product with wet hands.
  • Do not attempt to disassemble, repair, modify, or replace any part of your product.
  • Use this product only for its intended purpose as described in this user manual.
  • Do not use any accessories not recommended by the manufacturer.
  • When handling, installing, and operating the appliance, care should be taken to avoid damage to the refrigerant tubing.
  • Servicing shall be performed by factory authorized service personnel and component parts shall be replaced with manufacturer authorized replacement components.
  • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
  • Fill with potable water only.

CAUTION

  • Do not remove any safety, warning, or product information labels from your ice maker.
  • Lifting Hazard: It is recommended to have two people move and install the ice maker in order to prevent injury.

WARNING

Fire or Explosion Hazard Flammable Refrigerant

This appliance contains isobutane refrigerant, also known as R600a, a natural gas with high environmental compatibility. However, it is also combustible. Adhere to the warnings below to reduce the risk of injury or property damage.

  • When handling, installing, and operating the appliance, care should be taken to avoid damage to the refrigerant tubing.
  • Service shall only be performed by authorized service personnel. Use only manufacturer-authorized service parts.
  • Dispose of refrigerator in accordance with Federal and Local Regulations. The flammable refrigerant and insulation material used in this product require special disposal procedures. Contact your local authorities for the environmentally safe disposal of your refrigerator.
  • Keep ventilation openings in the appliance enclosures or in the built-in structure clear of obstruction.
  • To remove frost, scrape with a plastic or wood spatula or scraper. Do not use an ice pick or a metal or sharp-edged instrument as it may puncture the freezer liner and then the flammable refrigerant tubing behind it.
  • Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
  • Do not use any electrical device to defrost your appliance.
  • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
  • Do not damage the refrigerant circuit. This warning is only applicable for appliances with refrigerating circuits which are accessible by the user.

Parts Included

  • Side Tank
  • Base
  • Side Tank Clip

Getting Started

To keep your nugget ice tasting fresh and your Opal side tank looking great, we recommend cleaning/sanitizing your Opal and side tank at least once per week.

To clean the exterior of the ice maker, unplug the product, then use a soft cloth dampened with soapy water to gently clean the exterior surfaces. Dry with a soft cloth.

The exterior stainless steel surfaces can be cleaned with commercially available stainless steel cleaner. Use only a liquid cleaner free of grit and rub in the direction of the brush lines with a damp, soft sponge. Do not use appliance wax, polish, solvents, or chemicals on the stainless steel. Do not use soap to clean the reservoir. Use a soft cloth moistened with water.

WARNING

  • Chemical Exposure Hazard: When cleaning with bleach, use bleach in a well-ventilated area and avoid mixing bleach with other household cleaners.
  • Unplug the product before cleaning by hand, and when not in use.

Side Tank Accessory

NOTE:  Appearance may vary by model number.

There are two drain tubes located on the back of your Opal Nugget Ice Maker indicated as drain tube A and B in the illustration.

Hand Wash Only:

  1. Rinse and hand wash Opal Side Tank with warm water and a mild dish soap. Remove Opal Side Tank’s cap and wash the cap and rubber valve with water and a mild dish soap. The Side Tank base can be washed by disconnecting the hose and adding a small amount of soapy water to it. Scrub as needed and rinse thoroughly. The rinse water should drain out the port in the back.
  2. Unplug Opal Nugget Ice Maker. Unhook Opal’s drain tubes and drain the water from the reservoir.
  3. Connect drain tube, labeled B, to the back of Opal Side Tank’s base.
  4. Make sure drain tube (A) is connected to the black hanger and installed on the back of Opal.
  5. Make sure drain tube (B) connecting to the Side Tank is resting flat on the countertop.
  6. Place Opal Side Tank on the right or left-hand side of the Opal Nugget Ice Maker. Using the side tank attachment, slide the shorter side of the attachment under the unit, near the front of the unit. The attachment will slide into a slot on the bottom of the unit. Once this is placed, the side tank can slide onto the opposite attachment.
  7. Remove Opal Side Tank’s reservoir from its base.
  8. Unscrew Opal Side Tank’s cap from the reservoir. Fill the clear reservoir with water.
  9. Replace Opal Side Tank’s cap. Ensure the cap is clean when installing.
  10. Carefully flip over Opal Side Tank’s reservoir and place in the base. Water should start flowing into the Opal Nugget Ice Maker and bubbles in the Opal Side Tank will appear periodically during the time water is flowing to the ice maker.

NOTE:  If water does not appear to flow into the ice maker, please check for the following:

  • There may be bubbles in tube (B) connecting the Side Tank to the Opal.
  • Tube (B) is not lying flat.

If either of the above issues are present, adjust tube (B) to allow the water to flow. Once water starts flowing it typically will not need further adjusting.

  1. Fill Opal Nugget Ice Maker’s reservoir (if desired).
  2. Plug in Opal Nugget Ice Maker, and begin making ice.

Use and Care

Cleaning the Side Tank

  • Remove and drain the Side Tank.
  • If there is residual water in Opal Side Tank base unit, flip Opal Side Tank’s base to drain.
  • Remove and wash Opal Side Tank’s cap and valve with dish soap and warm water as needed. Ensure the cap is clean when reinstalling and re-installing by hand.
  • To drain after removing and to reinstall by hand.
  • Only remove drain tubes while near a sink or bucket, as removing drain tubes from Opal or Opal Side Tank will drain any water in either unit.

Proper Installation and Location

  • The side tank should be installed flush to the front of the Opal Nugget Ice maker. Opal Side Tank needs to sit on the same level surface as your Opal Nugget Ice Maker. Do not elevate Opal Side Tank, or your Opal may overflow.

To Remove Mineral Deposits:

  • Mix two quarts of water with two quarts of white vinegar, OR use the Opal Cleaning Kit.
  • Clean any visible mineral buildup or deposits with this solution. If deposits are present in the tank, fill the tank with this solution and let soak. Be sure to drain and rinse the tank thoroughly after cleaning. Stubborn deposits may require more than one treatment.

Troubleshooting

Normal Operating Sounds

Your new ice maker may make sounds that are not familiar. Most of these sounds are normal. Hard surfaces like the floor, walls, and countertops can amplify these sounds. The following describes the sounds that may be new to you and what may be creating them.

  • WHIR  – When Opal is first turned on, you may notice the condenser fan spinning.
  • BUZZ  – When the water pump first turns on, it may be dry and slightly noisy. Once it is filled with water, the noise reduces significantly.
  • RATTLE  – Rattling noises may be produced from the flow of the refrigerant. These noises should reduce significantly once the refrigerant system has stabilized.
  • GURGLE  – When the refrigerant system shuts off, there may be a brief gurgle as the refrigerant stops flowing.
  • HUM  – The compressor is a motor. It produces a low-toned humming sound while it is running.
  • CLICK  – As nugget ice is produced, it drops into the ice drawer. The first nuggets produced are the loudest, as they impact the bottom of the ice bin. As the bin fills, this noise reduces significantly.
  • SQUEAK  – When Opal is in need of defrosting, it may start to squeak as ice starts to build up around the mechanisms. The defrost cycle is automatic, and may take 30-45 minutes. During this time, the front button won’t respond.

Limited Warranty

For detailed warranty information, please refer to the warranty section in your product manual or visit the official GE Appliances website.

Consumer Support

If you have any questions or need assistance, please contact GE Appliances at GEAppliances.com/contact or call the customer support number provided in your product manual.

For product registration, visit GEAppliances.com/register.

For product returns or exchanges, visit myopalservice.com.

FAQs

Can I use the Side Tank for hot beverages?

The Side Tank is designed for cold liquids only. Do not use it for hot beverages to avoid damage.

Is the Side Tank dishwasher safe?

No, the Side Tank should not be washed in a dishwasher. Hand wash it gently to maintain its quality.

How often should I clean my Opal Side Tank?

We recommend cleaning/sanitizing your Opal and side tank at least once per week.

What should I use to clean the exterior of the ice maker?

Use a soft cloth dampened with soapy water to gently clean the exterior surfaces. Dry with a soft cloth. For stainless steel surfaces, use a commercially available stainless steel cleaner.

Can I use an extension cord with my Opal Ice Maker?

Due to potential safety hazards, we strongly advise against the use of an extension cord. If you must use one, ensure it is a UL-listed, 3-wire ground type appliance extension cord with a grounding type plug, and that the electrical rating of the cord is 15 Amperes (minimum) and 120 Volts.

What should I do if water does not flow from the Side Tank to the Opal Ice Maker?

Check for bubbles in the tube connecting the side tank to the Opal, and ensure the tube is lying flat. Adjust the tube if necessary to allow the water to flow.

What are the normal operating sounds of the Opal Ice Maker?

The Opal Ice Maker may produce sounds such as WHIR, BUZZ, RATTLE, GURGLE, HUM, CLICK, and SQUEAK. These sounds are normal and are described in detail in the troubleshooting section of this manual.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

GE Profile User Manuals

Related Manuals