GE Profile PFD87ESSVWH 7.8 cu ft Capacity Smart Front Load Electric Dryer Instruction Manual
- May 15, 2024
- GE Profile
Table of Contents
PFD87ESSVWH 7.8 cu ft Capacity Smart Front Load Electric Dryer
PFD87ESSVWW/ES(P/M)VRS
GE Profile™ 7.8 cu. ft. Capacity Smart Front Load Electric Dryer
with Steam and Sanitize Cycle
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
ELECTRIC DRYER RATING
120V/240V
|
5600W, 25A, 60Hz
120V/208V
|
4300W, 23A, 60Hz
EXHAUST OPTIONS: 4-way via rear, left, right, and bottom. (The right, left, and bottom venting options require Side Vent Kit: GFA28DSVN)
CIRCUIT REQUIREMENTS: An individual, properly grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay fuse, is required.
NOTE: Dryer wall outlet must be located within 36″ of service cord entry and accessible when dryer is mounted in position.
INSTALLATION INFORMATION: For complete information,
*With leveling legs retracted:
39-3/4″ (101 cm).
With leveling legs fully extended:
40-5/8″ (103.1 cm).
For answers to your Monogram, Café™, GE Profile™ or GE Appliances
product questions,
visit our website at geappliances.com or call GE Answer Center® Service,
800.626.2000.
PFD87ESSVWW/ES(P/M)VRS
GE Profile™ 7.8 cu. ft. Capacity Smart Front Load Electric Dryer
with Steam and Sanitize Cycle
Specification Revised 11/23
SPECIAL INSTALLATION REQUIREMENTS:
STACKED INSTALLATION:
– Brackets for stacking dryer over washer are not included with
the dryer. Order part no. GFA28KITN.
ALCOVE OR CLOSET INSTALLATION:
– If your dryer is approved for installation in an alcove or closet,
it will be stated on a label on the dryer back.
– The dryer MUST be exhausted to the outside.
– Minimum clearances between dryer cabinet and adjacent walls
or other surfaces are: 0″ all sides and top.*
– Closet doors must be louvered or otherwise ventilated and must
contain a minimum of 60 sq. in. of open area equally distributed.
If this closet contains both a washer and a dryer, doors must
contain a minimum of 120 sq. in. of open area equally distributed.
– No other fuel-burning appliance shall be installed in the same
closet with a gas dryer.
BATHROOM OR BEDROOM INSTALLATION:
– The dryer MUST be exhausted to the outdoors.
– The installation must conform with the local codes, or in the
absence of local codes, with the National Electric Code and
National Fuel Gas Code, ANSI Z223 for gas dryers.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INSTALLATIONS: Minimum clearances to combustible surfaces 0″ all sides
and top.*
FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.
DRYER ACCESSORIES**
GE Part Number
|
Description
---|---
WB64X5025
|
Touch-up Paint (White) .06 oz.
WH97X30578
|
Touch-Up Paint (Royal Sapphire) – 0.6 oz
WE02X29449
|
Dryer Rack Assembly
GFA28DSVN
|
Side Vent Kit
WE25X20060
|
Steam Kit
WX17X10001CA
|
Vibration Pads
GFP1528SNWW
|
Pedestal Assembly (White)
GFP1528PNRS
|
Pedestal Assembly (Royal Sapphire)
GFR0728SNWW
|
Riser (White)
GFR0728PNRS
|
Riser (Royal Sapphire)
GFA28KITN
|
Stacking Kit
WARRANTY
Labor Warranty
|
Limited 1-year entire appliance
---|---
Parts Warranty
|
Limited 1-year entire appliance
Limited 10-year motor
PEDESTAL DIMENSIONS (IN INCHES)
The optional 16″ pedestal raises the door
opening and height of the washer or dryer.
RISER DIMENSIONS (IN INCHES)
The optional 7″ riser raises the door opening and height
of the washer or dryer while remaining ADA compliant.
PFD87ESSVWW/ES(P/M)VRS
GE Profile™ 7.8 cu. ft. Capacity Smart Front Load Electric Dryer
with Steam and Sanitize Cycle
DRYER EXHAUSTING INFORMATION – METAL DUCT ONLY
For complete information, see installation instructions packed with your
dryer.
DUCTING MATERIALS: For best performance, this dryer should be vented with
4″ diameter all rigid
metal exhaust duct. If rigid metal duct cannot be used, then UL-listed
flexible metal (semi-rigid) ducting
can be used (Kit PM08X10084 or PM08X10085). In special installations, it may
be necessary to connect
the dryer to the house vent using a flexible metal (foil-type) duct. A UL-
listed flexible metal (foil-type)
duct may be used ONLY in installations where rigid metal or flexible metal
(semi-rigid) ducting cannot
be used AND where a 4″ diameter can be maintained throughout the entire length
of the transition
duct. Please see installation instructions packed with your dryer for complete
instructions when using
flexible metal (foil type) ducting.
EXHAUST LENGTH CALCULATION:
-
Determine the number of 90° turns needed for your installation. If you exhaust
to the side or bottom of dryer, add one turn. -
The maximum length of 4″ rigid (aluminum or galvanized) duct which can be tolerated
is shown in the table.
A turn of 45° or less may be ignored. Two 45° turns within the duct length
should be treated as a 90° elbow.
A turn over 45° should be treated as a 90° elbow.
Dryers must be exhausted to the outside.
CAUTION: For personal safety do not terminate exhaust into a chimney,
under any enclosed house floor
(crawl space), or into an attic, since the accumulated lint could create a
fire hazard or moisture could
cause damage. Never terminate the exhaust into a common duct or plenum with a
kitchen exhaust,
since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back
drafts, bird nesting, etc.
The wall cap must also be located at least 12″ above the ground or any other
obstruction with the
opening pointed down.
FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.
PFD87ESSVWW/ES(P/M)VRS
GE Profile™ 7.8 cu. ft. Capacity Smart Front Load Electric Dryer
with Steam and Sanitize Cycle
FEATURES AND BENEFITS
Steam Cycle – Refresh small loads and dewrinkle larger loads with the
power of steam.
Washer Link – Wirelessly links your washer to your dryer so you only
choose a setting once.
Built-in WiFi – Start, stop and monitor your laundry from anywhere
while receiving real- time notifications and updates.
Steam Sanitize – Sterilize clothing with elevated temperatures designed
to kill common household germs and bacteria, while using steam
technology to reduce wrinkles and odors.
Quick Dry – Quickly dries items and small loads for families on the go.
Reduce Static – Prevent static cling with a gentle mist near the end of
the cycle.
Wrinkle Care – Prevents wrinkles by extending the tumble without heat.
Damp Alert – Signals when delicate clothes reach the ideal dampness
level for ironing or final air drying.
Convenient 4-Way Venting – Flexible venting options allow venting
from the front, rear or either side with Kit GFA28DSVN.
Reversible Door – Easily reverse your washer and dryer doors for
superior installation flexibility.
Check Vent Notification – Receive a notification when the dryer vent
needs to be cleaned, ensuring safe operation and optimal drying
performance.
For answers to your Monogram, Café™, GE Profile™ or GE Appliances
product questions,
visit our website at geappliances.com or call GE Answer Center® Service,
800.626.2000.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>