POLAR UA201 Refrigerated Counter Instruction Manual

: July 4, 2024
: Polar

Table of Contents

POLAR UA201 Refrigerated Counter
Product Usage Instructions
FAQ
Safety Instructions
Pack Contents
Installation
Operation
Cleaning, Care & Maintenance
Troubleshooting
Technical Specifications
Electrical Wiring
DECLARATION OF CONFORMITY
Documents / Resources

POLAR UA201 Refrigerated Counter

POLAR-UA201-Refrigerated-Counter-PRODUCT

Specifications

Model: Refrigerated Counter
Material: Stainless Steel
Dimensions: Varies based on model (refer to specific model manual)
Power Source: Electric
Operating Temperature Range: Varies based on model (refer to specific model manual)

Product Usage Instructions

Installation

Remove the appliance from the packaging, ensuring all protective film is removed.
Maintain clearance around the unit for optimal performance and longevity.
Clean the interior with soapy water before initial use.
Set the brakes on the castors to secure the appliance in place.

Operation

Power Switch: Turn on the appliance by closing the door(s) and switching on the Power Switch.
Set Operating Temperature: Adjust the temperature using the SET button.
Manual Defrost: Initiate a manual defrost by pressing and holding the defrost button for 2 seconds.

Cleaning, Care & Maintenance

To prevent issues such as excessive ice formation and condensation, ensure regular cleaning and maintenance of the appliance. Follow the instructions provided in the manual for condenser cleaning and troubleshooting.

FAQ

Q: What should I do if my refrigerated counter is not working?

A: Check if the unit is plugged in correctly and switched on. If the issue persists, contact a qualified technician for repairs.

Safety Instructions

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.
Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.
Consult Local and National Standards to comply with the following:
Health and Safety at Work Legislation
BS EN Codes of Practice
Fire Precautions
IEE Wiring Regulations
Building Regulations
DO NOT use jet/pressure washers to clean the appliance.
DO NOT use the appliance outside.
DO NOT use this appliance to store medical supplies.
DO NOT stand or support yourself on the base, drawers, or doors.
DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.
Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the refrigerator.
Always carry, store, and handle the appliance in a vertical position and move by holding the base of the appliance.
Always switch off and disconnect the power supply to the unit before cleaning.
Keep all packaging away from children. Dispose of the packaging under the regulations of local authorities.
Children should be supervised to ensure that they do not play with the appliance.
This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience or knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
POLAR recommends that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity, and Functional Testing.
POLAR recommends that this product be connected to a circuit protected by an appropriate RCD (Residual Current Device).

Caution: Risk of Fire

Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
Warning: Keep all ventilation openings clear of obstruction. The unit should not be boxed in without adequate ventilation.
Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
Warning: Do not damage the refrigerant circuit.
Warning: Do not use electrical appliances inside the food storage compartments of the appliance.

Pack Contents

The following is included:

POLAR Refrigerator
Instruction Manual
POLAR prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.

Installation

Note: Not for use in vans or trailers, food trucks, or similar vehicles.
Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow to stand.

Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.
To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 20cm clearance on the top. NEVER LOCATE NEXT TO A HEAT SOURCE.
- Note: Before using the appliance for the first time, clean the shelves and interior with soapy water then dry well.
Set the brakes on the castors to keep the appliance in position.

Operation

Control Panel

A – Power Switch

Turn On

Close the door(s) of the appliance.
Switch on the Power Switch [I]. The current temperature within the appliance is displayed.

Set the Operating Temperature

Hold the SET button for 3 seconds. The value of the current set point will be displayed.
Press the or buttons to display the required temperature.
Press the SET button to store the temperature.

Manual Defrost

Press and hold the defrost button “aux” for 2 seconds to begin a manual defrost. The defrost light illuminates.
The defrost cycle will end automatically.

Cleaning, Care & Maintenance

Switch off and disconnect from the power supply before cleaning.
Defrost appliance at least every 3 months, more often if required.
Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
Take care when cleaning the rear of the appliance. Sharp edges can be cut.
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommended temperature range and placing next to a heat source will also increase the amount of ice and internal/external condensation.
If external condensation occurs wipe the surface down with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and increase the deterioration of components.

Condenser Cleaning

The condenser is part of the refrigeration system. The condenser requires monthly cleaning.
Always disconnect the power supply before carrying out Routine Maintenance.
Failure to clean the condenser will reduce the performance and life of your Polar unit and may invalidate your warranty.
These models have a removable filter which can be cleaned with a vacuum cleaner.

Troubleshooting

A qualified technician must carry out repairs if required.

Fault	Probable Cause	Solution
The appliance is not working	The unit is not switched on	Check the unit is

plugged in correctly and switched on
Plug or lead is damaged| Replace plug or lead
The fuse in the plug has blown| Replace the fuse
The mains power supply fault| Check the mains power supply
The appliance turns on, but the temperature is too high/low| Too much ice on the evaporator| Defrost the appliance
Condenser blocked with dust| Clean the Condenser
Doors are not shut properly| Check doors are shut and seals are not damaged
Appliance is located near a heat source or airflow to the condenser is being interrupted| Move the refrigerator to a more suitable location
The ambient temperature is too high| Increase ventilation or move the appliance to a cooler position
Unsuitable foodstuffs are being stored in the appliance| Remove any excessive hot foodstuffs or blockages to the fan
Appliance is overloaded| Reduce the amount of food stored in the appliance
The appliance is leaking water| The appliance is not properly leveled| Adjust the screw feet to level the appliance (if applicable)
The discharge outlet is blocked| Clear the discharge outlet
Movement of water to the drain is obstructed| Clear the floor of the appliance (if applicable)
The drip tray is overflowing| Empty the drip tray (if applicable)
The appliance is unusually loud| Loose nut/screw| Check and tighten all nuts and screws
The appliance has not been installed in a level or stable position| Check installation position and change if necessary

Technical Specifications

Note: Due to our continuing program of research and development, the specifications herein may be subject to change without notice.

Model| Voltage| Power| Current| Temperature Range| Refrigerant| Dimensions H x W x D mm| Weight (kg)| Net volume
---|---|---|---|---|---|---|---|---
UA020| 220-240V~

50Hz

| 300W| 1.8A| -2°C ~ +8°C| R600a 95g| 860 x 1795 x

700

| 154| 194L
UA021| 300W| 1.8A| -2°C ~ +8°C| R600a 95g| 860 x 2230 x

700

| 173| 284L

Note: For optimal product performance and efficiency, please ensure the net usable capacity (load limit) when filling.

Electrical Wiring

POLAR appliances are supplied with a 3-pin BS1363 plug and lead.
The plug is to be connected to a suitable main socket.

POLAR appliances are wired as follows:

Live wire (colored brown) to the terminal marked L
Neutral wire (colored blue) to the terminal marked N
Earth wire (colored green/yellow) to the terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required, they must be readily accessible.

Disposal

EU regulations require refrigeration products to be disposed of by specialist companies who remove or recycle all gasses, metal, and plastic components.
Consult your local waste collection authority regarding the disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.
Alternatively, call the POLAR helpline for details of national disposal companies within the EU.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste.
To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process.
For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
POLAR parts have undergone strict product testing to comply with regulatory standards and specifications set by international, independent, and federal authorities.

POLAR products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of POLAR.
Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserves the right to change specifications without notice.