Keychron P1 Pro Custom Gaming Keyboard User Guide
- July 3, 2024
- Keychron
Table of Contents
Keychron P1 Pro Custom Gaming Keyboard
OVERVIEW
PRODUCT USING INSTRUCTIONS
- Connect 2.4 GHz Receiver
- Connect the 2.4 GHz receiver to the device’s USB port.
- Switch toggle to 2.4GHz mode
- Note: For the best wireless experience, we recommend using the extension adapter for the receiver and putting the 2.4 GHz receiver somewhere on your desk close to your keyboard for a low rate of latency and fewer signal interferences.
- Connect Bluetooth
- Switch the toggle to Bluetooth
- Press Fn + 1 (for 4 seconds) and pair with a device named Keychron P1 Pro
- Connect Cable
- The Lemokey Launcher App
- Please visit launcher.lemokey.com to access the keyboard online launcher app.
- This app enables users to remap keys, adjust key actuation points, assign multiple commands to a single key, enter game controller mode, and more.
- If it cannot recognize your keyboard, please reach our support to get instructions.
- The online launcher App can only run on the latest version of Chrome, Edge, and Opera browsers.
- The online launcher App only works when the keyboard is connected by wire to the computer.
- Switch to Mac
- Please find the Mac keycaps in the box, and follow the instructions below to find and replace the following keycaps.
- Use the online launcher app to remap the Windows keys to Mac keys.
- The Backlight
- Press Fn + Q to change the lighting effect
- Press Fn + Tab to turn the backlight on/off
- Adjust The Backlight Brightness
- Press Fn + W to increase the backlight brightness
- Press Fn + S to decrease the backlight brightness
- Adjust The Backlight Speed
- Press Fn + T to increase the light effect speed
- Press Fn + G to decrease the light effect speed
- Factory Reset
Troubleshooting
Troubleshooting? Don’t know what’s going on with the keyboard?
- Download the right firmware and QMK Toolbox from our website.
- Unplug the power cable and switch the keyboard to Cable mode.
- Remove the space bar keycap to find the reset button on the PCB.
- Hold the reset key first, then plug the power cable into the keyboard. Release the reset key after 2 seconds, and the keyboard will now enter DFU mode.
- Flash the firmware with the QMK Toolbox.
- Factory reset the keyboard by pressing Fn + J + Z (for 4 seconds).
- Step by step guide can be found on our website.
Warranty
- The keyboard is highly customizable and easy to rebuild.
- If anything goes wrong with any of the keyboard components of the keyboard during the warranty period, we will only replace the defective parts of the keyboard, not the whole keyboard.
- Not Happy support@lemokey.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>