D-Link 10-100BASE-TX Fiber Interface Converters Installation Guide

June 3, 2024
D-Link

D-Link 10-100BASE-TX Fiber Interface Converters

D-Link-10-100BASE-TX-Fiber-Interface-Converters-PRO

INTRODUCTION

The New Fiber Converter Series DFE-855 series provides you with SC connectors for your fiber optic cable and RJ45 ports (straight through and crossover) for your 10/100Base-TX cable connection. The Fast Fiber Converters give you the freedom to extend your 10/100Mbps cabling distance by allowing connectivity up to 120 kilometers. Two LED indicators signal the UTP ink status and the Fiber tink status.

D-Link-10-100BASE-TX-Fiber-Interface-Converters-1 D-Link-10-100BASE-TX-Fiber-Interface-Converters-2

Specifications

Standard
IEEE802.3u 100BASE-TX, 100BASE-FX (Fast Ethernet, 100Mbps) Supports Full Duplex Ethernet mode (200Mbps)

100BASE-TX UTP Cable
Cable type: Category Se Maximum cable distance: 100 meters (328 feet)

Fiber Optic Connectors
Two connectors are provided for fiber optic cable connection. One is labeled Tx for transmission of optical data; the other is labeled “Rx” for reception of optical data.

D-Link-10-100BASE-TX-Fiber-Interface-Converters-3

NOTE: The Maximum possible fiber Cable length is 120 Kms.

Environment:

  • Temperature: 00 50°C
  • Humidity: 10-90% non condensing
  • Dimensions: 130mmx100mmx30mm
  • Power: 9V 1A AC/AC adapter

The below table explains the different LED status:

D-Link-10-100BASE-TX-Fiber-Interface-Converters-4

Installation alden

Connect the fiber interface cables to the DFE-855 series product Using a straight or cross UTP cable connect the Ethernet connection to the appropriate RJ-45 jack. Install the fiber converter with the AC power adapter provided (9V AC/AC) and connect the adapter to an AC outlet.

Connections
The following example illustrates the connection scheme when connecting from a 10OBASE-TX port of one SWITCH to a 100BASE-FX port of another SWITCH through the fiber converter.D-Link-10-100BASE-TX-Fiber-Interface-
Converters-5 The following example illustrates the connection scheme when connecting from a 100BASE-TX port of one HUB to a 100BASE-TX Network Interface Card (NIC) ina computer through the fiber converter.

D-Link-10-100BASE-TX-Fiber-Interface-Converters-6

TRADEMARKS
Ethernet is a registered trademark of Xerox Corp. ST is a registered trademark of AT&T.

WARNING: The information contained in this document is subject to change without prior notice.
This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference in which case the user will be required to correct the interference at his own expense.
NOTICE: (1) The changes or modifications not expressively approved by the party responsible for compliance could void the user’s authority to operate the equipment.
WARNING: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

D-LINK INDIA LIMITED
L5, VERNA ELECTRONIC CITY
VERNA, GOA. INDIA -403722

  • PH: +91-832-2885400/404/426
  • FAX: +91-832-2783395

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals