MOVO BPS2028R Medicine Cabinet with Mirror Installation Guide
- June 10, 2024
- MOVO
Table of Contents
MOVO BPS2028R Medicine Cabinet with Mirror
Product Information
The Medicine Cabinet (BPS2028R/BPS2028R-G) is a wall-mounted cabinet designed to store medicines and other small items. It comes with a single cabinet unit, two shelves, four wall anchors, and four mounting screws. The cabinet dimensions are 20 inches (W) x 28 inches (H) x 5 inches (D) and the shelf dimensions are 17-3/10 inches (W) x 22 inches (H) x 3-1/2 inches (D).
Product Usage Instructions
For recess-mount installations, follow these instructions:
- Choose a suitable location for the cabinet installation and mark the positions for the top and bottom edges of the cabinet.
- Use a stud finder to locate the studs in the wall and mark their positions.
- Drill four holes in the wall at the marked positions for the wall anchors.
- Insert the wall anchors into the holes and screw them in using the mounting screws.
- Place the cabinet into the recess and secure it to the wall by screwing it into the wall anchors.
- Attach the shelves to the cabinet by inserting them into the pre-drilled holes on the interior walls of the cabinet.
Make sure to follow all safety precautions when installing the cabinet and using it to store medicines. Do not exceed the weightlimit of the shelves or store items that are not suitable for medicine storage. Keep out of reach of children.
Assemble Instruction
Medicine Cabinet
BPS2028R
BPS2028R-G
List of Parts
Tools Needed
Rough Wall Opening
Use a 1/4 in. (6 mm) drill bit for dryvvall anchor installation. Use a 1/8 in. (3mm)drill bit for direct stud installation. NOTE: If installing into a material other than drywall or into stud, consult a professional for proper installation.
INSTRUCTIONS FOR RECESS-MOUNT INSTALLATIONS
INSTALLATION of CABINET
- Carefully remove all packing material. Place shelves and hardware aside until needed.
- Determine desired location of cabinet on wall. Mark wall to show wall opening size. Generally, the recommended height to the center of the cabinet is 64″ from the floor. Fig. 1 3.
- CAUTION: Wall studs, plumbing or electrical lines that interfere must be removed or relocated. Cut wall opening, being careful not to damage the surrounding wall surface. Insert framing to support all plaster board edges
- Insert cabinet into wall opening in plumb and centered position. Use a carpenter’s level and shim corners of cabinet if necessary.
- Once cabinet is inserted into wall, measure down 4″ from the top and the bottom of the cabinet. Center tihe measurement on the sides of the cabinet. Fig 2. 6.
- Using a drill bit, drill a total of 4 pilot holes in the locations determined in Step Secure to wall studs through the 4 mounting holes inside cabinet (screws provided)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>