Burns Barkles 022525 Wood and Coal Firepit Instruction Manual
- June 4, 2024
- Burns Barkles
Table of Contents
Burns Barkles 022525 Wood and Coal Firepit
SAFETY INSTRUCTIONS
Always follow the instructions.
- The product is only intended for outdoor use with wood as fuel. Do not use the product to burn refuse.
- Place the product on a level, nonflammable surface that can withstand rust stains.
- Never leave the product unattended when it is lit.
- Place the product at least 5 m from flammable material when in use and make sure that the area above the product is clear.
- Never move the product when it is lit – risk of fire and/or burn injury. Wear safety gloves when handling the hot product. Avoid if possible handling or moving the product before it has cooled.
- Never use petrol, alcohol or other flammable substances in the product.
- Keep children and pets at a safe distance from the product.
- Never attempt to extinguish the flames with water. Use sand.
- Do not fill the product with wood to more than 2/3 full before lighting.
- Never light the product in strong wind. Extinguish the fire if a strong wind starts blowing when in use.
- Always check after use that the product is clean and undamaged and that the metal is not badly burnt.
- The enamel can become discoloured at hot temperatures. This is a natural process and does not affect the capacity of the product.
- Avoid scratching or otherwise damaging the enamel, this can result in corrosion.
- Do not expose the product to rain or snow.
- Very high temperatures can result in minor damage to the enamel on the inside of the product.
- The first time the product is used it may smoke and smell a little. This is a result of a normal chemical process that makes the heat-resistant enamel harder. Allow the fire to burn for at least 40 minutes before cooking food.
SYMBOLS
| Read the
instructions.
---|---
TECHNICAL DATA
| Size | H 16.5 x Ø 40.5 cm |
|---|---|
| Weight | 2.7 kg |
USE
Remove the transport protection on the ends of the legs before using the product.
USING AS A FLOWER POT
- Place the product on a level surface.
- Water plants with a watering can, or equivalent.
- Do not water with a hose.
- Leave 5 cm between the surface of the planting soil and the top edge of the product.
- Avoid scratching or otherwise damaging the enamel, this can result in corrosion.
MAINTENANCE
Enamelled model
The product is treated with heat-resistant enamel that withstands temperatures
of up to 600°C, but it is not galvanised. Any scratches and wear during use
can therefore in time damage the surface treatment and result in corrosion.
This will not affect the functionality or capacity of the product. It is
recommended to touch up the product with heat-resistant enamel at least once a
year for best functionality and life span. Follow the instructions of the
enamel manufacturer.
Oxidised model
The product is made of untreated steel that oxidises in time and acquires a
typical rusty surface. The product does not require any special maintenance.
CLEANING
Enamelled model
Empty any ash and clean the product with a soft brush or cloth before use.
Oxidised model
Empty any ash and clean the product with a soft brush or cloth before use.