SANGSTRE-Listz Sport Audio Glasses User Guide

June 28, 2024
SANGSTRE

SANGSTRE-Listz Sport Audio Glasses

SANGSTRE-Listz Sport Audio Glasses

Introduction

This information is for reference only and does not constitute any form of commitment .

Power on / Power off

Press and hold the button for 2 second’s to power on/off. It will automatically power off if not connected to Bluetooth within 5 minutes.
Power on / Power off

Pairing

Automatically enter pairing mode when first booting.
Pairing

In the off state, press and hold the button for 5 seconds to actively initiate a new pairing.
Pairing

To maintain the connection with the current device, press the button for 5 seconds when device is turned off to establish a connection with the second device at the same time.
Pairing

Long press the button for 10 seconds to restore the factory settings.
Pairing

Music Mode

Click the button to pause when playing, dick again to continue playing.
Music Mode

Slide the right temple front or bock to adjust the volume up or down.
Music Mode

Double-dick the button to switch to the next song. Triple-dick the button to switch to the previous song.
Music Mode

More features

www.sangstre.com
www.sangstre.com.cn
www.sangstre.co.jp

QR Code

Phone Mode

In the Call state, dick the button once to answer the Call, double click the button to hang up.
Phone Mode

When the second call comes in, dick the button to keep the current call and Connect the second Call, double click the button to reject.

In the call state, double click the button to hang up.

During a three-way call, double-click the button to hang up the current call and switch to the held call.
Phone Mode

Intelligent control

In Bluetooth connection status, double touch on the right logo to start the voice assistant.
Intelligent control

Optical sensors can identify the user’s wearing state and inteligen11y control the glasses.
Intelligent control

FCC Caution

  1. 15.19 Labelling requirements.
    This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

  2. 15.21 Changes or modification warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

  3. 15.105 Information to the user.
    Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals