welldana PL-REM-60 Link Driver Instruction Manual

welldana PL-REM-60 Link Driver

Technical specifications

Electrical specifications

• Nominal Input voltage
  

  • 230 VAC 50 Hz

• Output voltage on Lamp Output

  • 12 VAC

• Max output current on Lamp Output

  • 5A

• Transformer VA rating
  

  • 60VA

• Frequency band transmitter
  

  • 868 MHz

• IEC Protection Class

  • Class II

General specifications Controller

• Ambient air temperature

  • 0°C … +40°C

• Humidity
  

  • 10% … 90% RH

• Dimensions
  

  • non condensing  150x157x51 mm

• Weight
  

  • 1,3 kg

• Ingress Protection Rate

  • IP54

Box contents

1. PL-REM-60 controller
2. Handheld transmitter
3. Spare battery
4. Screws (4x) & wall plugs (4x)
5. Owner’s Manual

Installation instructions

• Connect a 230VAC power source to the “220-240VAC INPUT” terminal.
• Connect the swimming pool lights to the “Lamp 12VAC output” terminal
  • Make sure the total load of pool lights does not exceed 60Watt

Pairing handheld transmitter & controller

The handheld transmitter is already paired in the factory and ready to use. The PL-REM-60 can pair with up to 6 handheld transmitters. In case a problem arises, the pairing process can be done manually:

Manual Pairing process
Make sure the PL-REM-60 is connected to a power source.

1. Press the pairing button on the small circuit board, inside the controller for at least 5 seconds.
   • The LED will start to blink fast
2. Within 25 seconds, press any button on the handheld transmitter.
   • If the transmitter is paired correctly, the LED will flash slowly for 5 times
   • If the PL-REM-60 pairing memory is full, the LED will flash 15 times. This means 6 handheld devices have already been paired. To unpair all handheld transmitters with the controller: Push the pairing button for at least 5 seconds, then do nothing for at least 25 seconds.
   • The pair memory will be erased – the green LED will flash 5x on/off.

If no transmitters are paired, the PL-REM-200 will accept messages from any transmitter!

Handheld transmitter functions

Replacing transmitter battery

• Remove the philips head screw and open the transmitter
• Replace the battery, respecting the polarity
  • Battery type : A23 12V

Troubleshooting

PROBLEM/SOLUTION

• The controller doesn’t react to transmitter commands
  • Check the battery of the hand-held transmitter
  • The transmitter is not paired correctly with the controller. Repeat the pairing process
  • Reduce the distance between the handheld transmitter and PL-REM-60 and/or eliminate obstacles
• The pool lights don’t work
  • Check the red status LED
  • Check if there is 12VAC output at the terminals of the controller

Declaraction of Conformity
Declarations of conformity covering this product are available for download from the House of Duratech website: www.duratech.be

Notes

Contact details
Propulsion Systems bv Dooren 72 1785 Merchtem, Belgium

• Tel +32 2 461 02 53
• www.duratech.be
• info@propulsionsystems.be

We reserve the rights to change all or part of the contents of this document without prior notice

References

• Duratech | Homepage

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>