GEN2WAVE Prime RS01 Android 13 Multi Mode 5G LTE Smart Module User Manual

: June 26, 2024
: GEN2WAVE

Table of Contents

7 floor, Point town B/D, 187-4, Gumi-dong, Bundang-gu, Seongnam-si, Gyeonggi-

GEN2WAVE Prime RS01 Android 13 Multi Mode 5G LTE Smart Module User Manual

Google, Android, Google Play and other marks are trademarks of Google LLC.

FCC Part 15 Information and Notices
This device complies with part 15 of the FCC Rules.
Operation is subject to conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

7 floor, Point town B/D, 187-4, Gumi-dong, Bundang-gu, Seongnam-si, Gyeonggi-

do, 463-870, Rep. of Korea
Tel. +82-31-607-7537 Fax. +82-31-608-7537
Homepage : www.gen2wave.com Email : tcs@gen2wave.com

Specification

Package

PRIME RS01

Quick Manual

NOTE. Items in the box may be changed according to the purchase order.

Device Features

Card Installation

How to Insert SIM cards and a MicroSD card
① Pull out the cover of the USIM(nano) and MicroSD slots.
② Insert USIM card and Micro SD card into the slot.
③ Slide the slot into the device.
USIM and MicroSD card can be removed in the reverse order

Caution. If the device is powered on and the SIM card is inserted, the device must be rebooted.

Charging the Device

Charging
① The device battery can be charged by plugging in power cable to USB-C port.
② When charging, the charging status LED of the device lights up, red when charging, and green when charging is complete.
③ Battery LED indicates as follows :
● OFF : Not Charging Red LED : Charging Green LED : Fully Charged

Note. Devices supports high-speed charging.
Adapter voltage must be 5~9V and current is 2A or higher recommended.

Caution. Charging speed is slow when using a PC’s USB port or adapter with less than 2A current.

How to use functions

Barcode Scanner

The laser aimer should be on the center of the barcode to get a successful read.

NFC Reader

Since NFC antenna is integrated in the rear side of the device, read the contactless card as shown.

NFC reading distance depends on the NFC card type.

How to use power

Power On
▪ Press the power button for 1 second to turn on the device.
▪ The power LED briefly turns green on the screen, then turns off, and the GEN2WAVE logo appears.
Power Off
▪ Press the power button until the system menu appears and touch Power off icon.
Soft Reset
▪ Press the power button until the system menu appears and touch Restart icon.
Hard Reset
▪ Press and hold the power button for approximately 10 seconds to reboot the device..
Factory Reset
▪ Follow the below steps to Factory Reset.
▪ Path : Settings → System → Reset options → Erase all data (factory reset) → Erase all data

Caution. Factory Reset : Erase all data and restore default setting

SAR. This device has been tested and meets the FCC RF exposure limit. FCC SAR has been tested with 0mm distance for head SAR, 15mm for Body SAR, 10mm for Hotspot SAR and 0mm for Extremity SAR.