renowatt MTN-94201 Power Station User Manual

June 26, 2024
Renowatt

renowatt MTN-94201 Power Station User Manual

WHAT’S IN THE BOX

Overview

CHARGING

This is some common devices (within 1000W)

Rechargement

Before using or storage,plug your Power Station into the wall plug until it is fully charged.
lf the LCD shows less than 20% capacity, plug it into a power source, like an AC outlet or a solar panel, as soon as possible.
There are four ways to recharge your Power Station:
DC 5.5*2.5mm Input

SPECIFICATIONS

ATTENTION

DISCLAIMER

Our company cannot be held liable for damages caused by fire, earthquake, used by a third party, other accidents, intentional misconduct on the part of the customer, abuse or other abnormal conditions.
Do not repair any damage to the AC plug or power supply on your own.
The warranty covers all terms and conditions of the warranty. Contents that are not specified in the warranty terms and conditions are beyond our responsibility.
Our company assumes no liability for damage caused by incorrect use or non- compliance with this instruction manual.
Intended use: The power station unit is intended as a power supply for electronic devices with a
maximum power consumption of 1000W. Our product is not suitable to be used with equipment that relates to one’s own personal safety and relies heavily on electricity, such as medical devices, equipment for nuclear facilities, the manufacture of air and spacecraft, etc. We therefore assume no liability for accidents involving personal safety, fires, or machine failures, caused by using our product with the aforementioned devices.

POWER

  1. LCD Screen Button
  2. Press the LCD button to check the remaining battery.
  3. AC Button/DC 12V Button/USB Button
  4. Turn on each output by pressing its power button before charging your device as it does not output automatically. Turn off each output by pressing its power button as it does not tum off automatically or it will drain the battery out.

SAFETY INSTRUCTIONS

Read the following instructions to ensure safe usage

DANGER

Noncompliance may very likely lead to serious injury or death

  1. DO NOT disassemble, repair or modify the unit or the battery.
  2. DO NOT place the unit close to or in a fire or expose it to heat. Keep out of direct sunlight.
  3. DO NOT charge,use or store the unit in a bathroom or in an area exposed to rain or moisture
  4. Only use the output socket to power external devices. Never connect the output to mains power under any circumstances.
  5. DO NOT touch the unit or the plug-in points if your hands are wet.
  6. DO NOT connect any metallic objects to the AC input or output.
  7. DO NOT rub your eyes if fluid from inside the unit should get in your eyes.
  8. DO NOT use any inappropriate power cords.
  9. DO NOT operate the unit above the specified input voltage.
  10. DO NOT use the unit if it is not functioning correctly.
  11. DO NOT move the unit if it is reharging or in use.
  12. DO NOT put fingers or hands into the product.
  13. DO NOT use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredicable behavior resulting in fire, explosion or risk of injury.
  14. DO NOT disassemble the power pack, take it to aqualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or electric shock.

WARNING

Noncompliance may lead to serious injury or death

WARNING- RISK OF EXPLOSIVE GASES

To reduce risk of battery explosion, follow these instructions and those published by battery manufacturer and manufacturer of any equipment you intend to use in vicinity of the battery. Review cautionary marking on these products and on engine.

LCD

Power Level Percentage
Check the battery level by pressing the display button before using it. If the battery is at a low level, charge first.

Power of Input & Output (W)
If the Power Station’s total output exceeds 1000W, it will automatically shut off.
Please ensure the power consumption is less than 1000W, then press the power button.

Low & High-Temperature Alarm

The can power your devices at temperatures ranging from -10~40°C(14~104°F).
If your working temperature is outside this range, they may stop working.

Warning symbol

  1. Input overvoltage protection
    The symbol flashes for 5 seconds and then turn off the input. When input overvoltage protection is released, the symbol will not display again.

  2. Output overload protection
    The symbol flashes for 5 seconds and then turns off the output.
    The symbol will not be displayed when the overload is removed.

  3. Lower Power Alarming
    This symbol flashes to indicate that the product is in a low power state, power less than 3%.

  4. Low temperature alarming
    When this symbol display, please stop charging or discharging this power station immediately to avoid damaging.

  5. High temperature alarming
    When this symbol display, please stop charging or discharging this power station immediately to avoid damaging.

  6. LED FLASHLIGHT
    Short press the button: weak light – bright light – strong light – turn off cycle in turn.
    Double click the button to turn on SOS function and press the button again to turn off the lighting.

LED FLASHLIGHT

Short press the button: weak light – bright light – strong light – turn off cycle in turn.
Double click the button to turn on SOS function and press the button again to turn off the lighting.

PERSONAL PRECAUTIONS

  1. NEVER smoke or allow a spark or flame in vicinity of battery
  2. Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery or other electrical part that may cause explosion.
  3. DO NOT expose a power pack to fire or excessive temperature. Exposure fire or temperature above 130℃ may  cause explosion.

CAUTION

Noncompliance may lead to inuries and /or property damage.
If rust, peculiar odors, overheating or other abnormal circumstances are observed, stop using the unit immediately and contact the dealer or our customer service center.
The unit complies with all legal requirements for transport of dangerous goods.
Make sure that the unint is properly secured when transporting it in a motor vehicle.
Only charge, use and store the unit within an ambient temperature of 0 to 40 (32 – 104F)
Switch the unit off immediately if it has ccidentally fallen, was dropped or was exposed to vibrations.
Carefully read the instructions for the electric devices that you intend to connect to your power supply unit.
Make sure that the device you are connecting is switched off before you connect it.

WARRANTY

Limited Warranty
Our company warrants to the original comsumer purchaser that the our company product will be free from defects in workmanship and material under normal consumer use during the applicable warranty period identified in the
” Warranty Period” section below, subject to the exclusions set forth below. This warranty statement sets forth our total and exclusive warranty obligation. We will not assume, nor authorize any person to assume for us, any other liability in connection with the sale of our products.
Warranty Period
The warranty period is 12 months. In each case, the warranty period is measured starting on the date of purchase by the original cunsumer purchaser. The sales receipt from the first consumer purchase, or other reasonable documentary proof, is required in order to establish the start date of the warranty period.
Remedy
Our company will repair or replace (at our option) any our company product that fails to operate during the applicable warranty period due to defect in workmanship or material. If a valid claim is made during the applicable period, our company, at its option, will either(1)replace the product, or (2) exchange the product with a product that is of equal value. A
replacement product assumes the remaining warranty of the original product or 180 days from the date of replacement, whichever is greater. Coustomer is responsible for the return shipping costs.
Limited to Original Consumer Buyer
The warranty on our product is limited to the original consumer purchaser and to any subsequent owner.
Exclusions
Our warranty does not apply to (i) any product that is misused, abused, modified, damaged by accident, or used for anything other than normal consumer use as authorized in our current product literature, or (ii) any product purchased through an online auction house. our warranty does not apply to the battery cell unless the battery
cell is fully charged by you within seven days after you purchase the product and at least every 6 months thereafter.
How to Receive Service
To obtain warranty service, contact our customer service team

The information contained herein is subject to change without notice. The only warranties for our company products and services are set forth in the warranty statements accompanying such products and services. our company shall not be liable for technical or editorial errors or omissions contained herein.This user guide describes features that are common to most models.

FAQs

What type of battery is in an Power Station ?
Contains a battery pack which consists of an array of cylindrical Lithium- ion battery cells with high energy density.

How do I know if my Power Station is charged?
To Check the charge level of the refer to the LCD battery Display.

Can I charge the while supplyiing power at the same time?
The power station could power the devices while recharging itself.

How do I know if my device will work with the ?
You will need to check the amount of power your device requires. This may require some research on your end. An online search or examining the user guide for your device should suffice. To be compatible with the you should use devices that require less than 1000W.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals