GYROCOPTERS Plaid Off Road Electric Scooter Instruction Manual

GYROCOPTERS Plaid Off Road Electric Scooter

AID ELECTRIC SCOOTER

INSTRUCTION MANUAL

HELMETS SAVE LIVES!

Always wear a properly fitted helmet that complies with CPSC or CE safety standards when you ride your scooter.

Correct Fitting
Make sure your helmet covers your forehead.

Incorrect Fitting
Forehead is exposed and vulnerable to serious injury.

GENERAL SAFETY DIRECTIVE

• Before each use, thoroughly check the whole device, such as motor, front-wheel, folding joints, etc., whether the locking screws are fastened and reliable. Do not drive at will before correcting any problem.
• Don’t try to jump the curb/highland more than 3 cm away because it can cause damage to the scooter.
• We recommend not to use Gyrocopters Plaid Electric Scooters on rough roads and ground because it increases the likelihood of tire damage.
• Do not charge outside or use this product below -5 c.
• Pregnant women, disabled people and people with heart problems should not use this product.
• Gyrocopters Plaid Electric Scooter is a way to move alone. Our technology and production processes are both been developed and validated through very rigorous testing.

BATTERY SAFETY INSTRUCTIONS

• Batteries should not be exposed to overheated environments such as sun, next to fire or similar high temperatures.
• If the Gyrocopters Plaid Electric Scooter is not used for a long time, the battery should be fully charged every 90 days. Otherwise, the battery will discharge itself and be damaged.
• If the battery releases a strong smell or heat, stop using the product immediately. Do not privately open the product. Always contact [email protected] if you need any assistance.

CHARGER SAFETY INSTRUCTIONS

• Carefully check the power plugs and cables for damage before use.
• Always use the original charger provided with the product.
• Product charging must be conducted in a well-ventilated environment. Once the battery is fully charged, the charger should be disconnected immediately.
• Keep the charger away from children.
• Disconnect the battery and charger and cool it down before cleaning, storing, and shipping.
• Protect the charger and other electrical components from dampness. Do not soak them in liquid when cleaning or in use.
• Maintenance must be carried out by authorized professionals. Always contact [email protected] if you need any assistance. Incorrect assembly may cause a fire or electrical shock.
• Do not charge near flammable items.
• When using the charger, ensure that the charger and the charging port are well connected and not blocked by external objects.

KNOW YOUR GYROCOPTERS PLAID ELECTRIC SCOOTER

Note: Gyrocopter Plaid is not a front-wheel motor model

SPECIFICATIONS

Top Speed
Climbing Ability
Terrain
Operating Temperature
Charging Time
Storage Temperature
Battery Parameters| Capacity
| Voltage
Motor Dimensions
1247x675x556

23.6kg
45Km/H
30 Degrees
Cities & Mountains
-5-40 Degrees
4-5 Hours
-20-40 Degrees
10Ah
48v
10 Inches
Motor parameters| Maximum Torque
---|---
| Voltage
Rated Power
Maximum Power
Motor Type
Brake| Brake Braking Mode
| Brake Stop Distance
Tire| Outer Tier Size
| Outer Tire Pattern
Charger| Input The Voltage
| Maximum Load
32N

48v
800W
1000W
Rear Brushless
Front And Rear Mechanical Disc Brake
<4.57 M
10×2.75×6.5 Off-Road Tire
Off-Road Pattern
100V~240V
150KG

USER GUIDE
This section provides information about how to use the product correctly. Following these instructions is necessary for the safety of the user and the service life of the product.

Insert the handlebars into the tube and lock it with 4 screws.

Close the folding plug, buckle the lock, and twist the lock.

• On/Off Switch : Press 2 seconds to turn the scooter On or Off.
• Lights Switch : Click the switch once to turn on all lights and click twice to turn off all the lights.
• Horn Switch : Press and hold the horn switch for horn sound, and release the horn switch to stop the sound.
• Speed Switch : Click the speed switch once to shift from Eco to standard speed mode. Click twice to switch to sports mode.
• Mode Settings : Click on the mode switch to shift between metric and imperial modes.
• Turning Switches : Press the left and right turning switches to turn on the corresponding turn indicator lights.

DISPLAY MODULE

• Battery Indicator : Six led light bars on the display show the battery level. It is recommended not to drain the battery by 100% and charge it before use.
• Left & Right Turn signal– The left and right turn signals indicate the corresponding lower turn light flash while you are steering left or right.
• Double-drive mode : Double-click the headlight switch to shift to a dual-drive mode. [Applicable only for Dual Motor Models]
• Bluetooth connection: The display board has a Bluetooth symbol, indicating the scooter is connected to mobile Bluetooth and the app functions are active.
• Cruise Control : Turn on the cruise speed function by holding down the accelerator till you hear a beep. Once the cruise control is active you can release the acceleration handle, the vehicle will continue to ride at a uniform speed. Cruise Control gets deactivated if vou brake or press the acceleration bar again.
• Light Symbol : After the vehicle is powered on, press the headlight switch once to switch on all the lights. A light Symbols appear on the display when all the lights of the vehicle are turned on.
• Pedestrian mode : Walking mode symbols on the instrument display when the vehicle speed is less than 6Km/h.
• Maximum speed : It shows the top speed of the whole ride.
• Current speed : The display shows the current speed.
• Single mileage : Show the current mileage during the ride, and automatically return to zero after turning off the power supply.

GYROCOPTERS PLAID ELECTRIC SCOOTER OPERATION

Wear your helmet and personal protection gear before riding to avoid injuries.

GYROCOPTERS PLAID ELECTRIC SCOOTER OPERATION

• Press the power switch and turn on the vehicle power supply, confirm that the power is sufficient before riding.
• Standing on the deck with one foot on deck, press the acceleration once the scooter has gained momentum put the other foot on deck.
• Press the acceleration switch on the handle to accelerate, release the switch to decelerate
• Press the real and front brakes at the same time in case of an emergency, braking with only the front brake may cause an accident.
• When turning, please slow down and turn the handlebars slowly.

FOLDING THE SCOOTER

• Turn the fold connector knob counter- clockwise until the fold connector buckle no longer holds the connector
• Fold the handlebars and tubes to the rear fender.

WHAT’S IN THE BOX
1 vehicle; 4 M5*P0.8 screws, 1 x internal hexagon wrench, 1 charger

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>