dyras TB-4696X Blender Instructions

Dyras TB-4696X Blender

SAFETY PRECAUTIONS

• Read all instructions carefully before you use the appliance!
• Always disconnect the appliance from the supply if it is left unattended and before assembling, disassembling, or cleaning!
• This appliance shall not be used by children. Keep the appliance and its cord out of reach of children!
• Appliances can be used by persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved!
• Children shall not play with the appliance!
• If the supply cord is damaged, it must be replaced by the manufacturer, its service, agent, or a similarly qualified person to avoid a hazard!
• Care shall be taken when handling the sharp cutting blades, emptying the bowl, and cleaning!
• Switch off the appliance and disconnect the ROM supply before changing accessories or approaching parts that move in use!
• Ensure fingers are kept well away from the blades when in use!
• This appliance is intended to be used in household and similar applications such as：
  • staff kitchen areas in shops, off, ice, and other working environments;
  • by clients in hotels, mo, tels residentialtial-type type environments;
  • bed and breakfast type environments.
• Do not blend hot ingredients!
• Always operate on a flat surface!
• Ensure the control dial is in the off ‘0’ position before plugging ing into the power outlet!
• Do not operate for more than minutes at a time!
• Read carefully and save all the instructions provided with an appliance!
• Always turn the power off at the power outlet before you insert or remove a plug! Remove by grasping the P lug， do not pull on the cord!
• Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person!
• Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance!
• Do not use an appliance for any purpose other than its intended use!
• Do not place an appliance on or near a hot gas flame, electric element, or a heated oven. Do not put ice on top of any other appliance!
• Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface!
• Do not operate any electrical appliance with a damaged cord or after the appliance has been dropped or damaged in any manner!
• Do not immerse the appliance in water or any other liquid unless recommended!
• Never touch the blades while the machine is plugged in!
• Take special care when emptying and cleaning the blender jug, as the blades are extremely sharp!
• Regarding the instructions for cleaning surfaces in contact with food, thanks to refer to the section “Care and Cleaning”.
• Regarding the operating times, therefore refer to the section “A Guide to Your Blender”.

IDENTIFICATION OF PARTS

1. Measuring cup
2. Lid
3. Glass bowl
4. Blade
5. Glass bowl holder
6. Body
7. Start knob
8. Function button
9. Rubber feet

USING YOUR BLENDER

• Wpluggingplug in the appliance, three function buttons will with blue flashing light. After the glass jar is fixed, the light will stop flashing.
• The start knob allows you to use various ety speeds from mini power to max power.
• When you the use start knob for your speed control, the function button cannot work in the meantime.
• Three function buttons for your reference
• When you use the ing function button for your food, you can change dressingsessingss based on oonhe needed Besides can also choose to use the start knob for speed control, after you do that, you cannot use the function button in the meantime.
• The glass jar is 1.5 L.

Blending The ith Speed knob

• Pour in the ingredients and cover the glass bowl (Fig. 1), and then place the bowl into the host (Fig. 2) and turn clockwise (Fig. 3). Lift the glass bowl to check it is locking whether or not.
• Plug in the appliance and rotate the start knob to which speed you need.
• At the end of preparation, rotate the start knob to position OFF, unplug the appliance and wait until the blades come to a complete stop.
• Remove the glass bowl and take off the lid, then pour out the ingredients.

Blending the ith function button

• Pulse function
  o When you press the ess button “Pulse”, you should press it continuously, when the foods are finished, please release it.

•  Ice Crushing function
  o When you press this button, a cycle is working for 1s and stop 1s, this will last for 30s.

•  Smoothie function
  o When you press this button, it will work with 90%power for 1min.

Baby Food

• To mix or blend cooked food:
  o Chop the food into small pieces, add some broth (meat or vegetable, less), and mix the ingredients with pulses. To blend the mixed food, rotate the start knob till you reach the desired result.

• For fruit preserves
  o Chop the fruits into small pieces, add some milk, w,ater or j juice,e and mix the ingredients with pulses. To blend the fruits, rotate the start knob till you reach the desired result.

CAUTION

• Maximum time of processing should not exc1-minutenute continuous uTor to achieve below processing times, use the appliance with pulses and intermedi10-second cond pauses.
• Do not operate the unit when empty.
• Do not put hot ingredients into the bowl. Before food preparation allow food to cool down for a few minutes.
• Before you eat or serve blended food, please always check for ingredients that might have not been blended adequately.

CARE AND CLEANING
Unplug the appliance and detach all the accessories before cleaning the Blender jug with warm and a small amount of detergent.

1. Use the ‘Pulse’ function and hold for 1-2 seconds and release. Repeat 3-4 times.
2. Then remove the jug or cup and rinse them under running water.
3. For thorough cleaning, wash the Blender lid, Measuring, cup, and Blender jug in warm soapy water.
4.  The Blade base can be cleaned in running water in the direction of the blades upwards. Do not flush the bottom of the Blade base.

Note
These parts can also be cleaned in the dishwasher.

Caution
Take care when cleaning the blades as they are extremely sharp.

To clean the motor base
Use a damp, soft sponge with detergent and wipe over the motor base.

Note
 Never immerse the motor base in water.

STORAGE

1.  Wrap the power cord around the device.
2.  Store in a cool and dry place.

SPECIFICATION

• Rated voltage: 220-240 V;
• Rated frequency: 50 Hz / 60 Hz,
• Rated power: 1200 W
• Class against electrical shock: II.

WASTE MANAGEMENT

Correct Disposal of this product
This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product environmentallyntal safe recycling. Manufacturer
CE SYMBOL

DEAR CUSTOMER
Please note that the following operating, storage, environmental, and environmental conditions may affect the lifetime and usability of the device, and may adversely affect, shorten, or prolong its life if not permanently or temporarily.
Always protect your device from the following: The mark is intended to indicate that the product complies with the relevant European Union standards and can be freely marketed in the European Union.

• Use or storage in a humid, damp environment may cause
  • premature aging of the device’s enclosure,
  • electrical insulation,
  • premature wear and aging of the structural components of plastics and rubber
  •  Impro and and, accelerate the corrosion of electrical units, wires oxidation, and metal parts.
• Use in dusty environments or in kitchens (where the atmosphere is exposed to, for example, cooking oil or cooking fat) may cause
  • The deposition of greasy powder coating on the mechanical and electrical components and casing of the unit can cause electrical contact failure, even total malfunction, and damage to plastic and rubber components.
  • Direct sunlight can cause:
  • Premature aging of the device casing, plastic and rubber parts, deterioration of strength and other structural features, po,sity, and brittleness of their surface, which may endanger proper, safe use.
• Continuous industrial use may cause
  • Premature structural wear due to forced operation of the device, premature engine wear,
  • damage due to continuous wear and overheating
• Device storage in fold conditions may cause
  •  Structural damage or breakage of plastics and rubber parts that endanger the intended safe use,
  •  Oxidation due to condensation, and corrosion of metal parts of the device.
• Can be caused by radiation or direct heat (such as providing an inappropriate distance from the stoor or, radiator
  • structural damage, deformation, deformation, softening, melting, or weakening of electrical insulation of plastic and rubber parts, and coverings.

To prolong the life of the device and prevent improper use, avoid or prevent the above conditions and always follow the product operating instructions, otherwise, you will be responsible for improper operation for which the manufacturer assumes no responsibility. We recommend that you have your appliance periodically inspected by an authorized service center if you do not experience any malfunctions, as this may help you troubleshoot an early-stage problem and increase the life of your product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>