HYPER TOY HYP-HRC-2001 RC Stunt Truck Dozer Instruction Manual
- June 5, 2024
- HYPER TOY
Table of Contents
**HYPER TOY HYP-HRC-2001 RC Stunt Truck Dozer Instruction Manual
**
CONTENTS
-
Vehicle
-
Remote Controller
-
Instruction Manual
-
Rechargeable Battery
-
USB Charging Cable
BATTERY ISNTALLATION
Back of Vehicle
- Unscrew the screw on top of battery cover by screw driver.
- Put 2 1.5V AA batteries in the battery slots with correct polarity.
- Close the battery cover and tight the screw with screw driver.
Bottom of Vehicle
- Unscrew the screw on the top of battery cover by screw driver
- Put the rechargeable battery in the battery slots and connect it to the vehicle.
- Close the battery cover and tight the screw with screw driver.
Charging the battery 90 minutes
Note:
If the remote control cannot control the car, first remove batteries and re- install them. Then turn off the power of remote control car, then turn it back on the power The remote control will reset the frequency.
FUNCTION
-
Push both throttle levers up to move the vehicle forward.
-
Push both throttle levers down to move the vehicle backwards.
-
Push the left throttle lever up to turn the vehicle right
-
Push the fight throttle lever up to taro the vehicle left.
-
Push the left throttle lever down and the right throttle lever up to rotate the vehicle left on the spot.
-
Push the left throttle lever up and the right throttle lever down to rotate the vehicle right on the spot.
-
Press the shoves arm function key. button to raise the arm rises up,; press the button again the function key to lower the arm goes down.
-
Push both throttle levels up at the same time to move the car forward, then push the two throttle levers down at the same time to roll the vehicle over (when rolling the shovel arm will tuck away).
This device complies with Industry Canada licence-exempt RSS 210 standard. Operation is subject to the following two conditions: (1) this device may not cause interference. and (2) this device must accept any interference. including interference that may cause undesired operation of the device.
Battery Safety Information:
Insure that battery polarity is correct. Use only batteries of tie type recommended (or equivalent). Do not mix old and new batteries. Do not mix alkaline. star card Icarbon-zinc), or rechargeable (nickel-cadmium) batteries. Rechargeable batteries arc to be recharged by Adult only Remove used-up batteries immediately. Do not recharge non-rechargeable batteries. Do not short-circuit terminals. Dispose of batteries safely. Do not dispose of batteries (or products containing non-rechargeable batteries) in fire. as batteries may explode or leak.
This device complies with be Part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE This equipment has been tested and found to comply with the limits for a (lass 3 digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy ard. If not installed and used n accordance with the instructions, may cause harmful interference to radio communications. However, there ‘s no guarantee that interference wit not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio TTV technician for help.