dyras PHW-K10D Wall Mounted Heating Instruction Manual
- June 24, 2024
- dyras
Table of Contents
dyras PHW-K10D Wall Mounted Heating
Please carefully read the instructions before using!
SAFETY INSTRUCTIONS
-
The heater should be hung on the wall and make the wind outlet down. You must not place it precipitantly or tipsily.
-
Please do not use the heater in the place where full of combustible or explosive gas.
Don’t cover the wind outlet. -
If the supply cord is damaged, do not use the appliance and the cord must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
-
The heater must not be located immediately below a socket-outlet.
-
The electrical-outlet must be equipped with installment of earth whose capacity should be 220-240V, 50-60Hz.
-
Make sure the socket and plug contact well.
-
It can only be operated under continuous supervision!
-
Please don’t touch the heater by the wet hand or other conductor.
-
If the motor is out of order, please stop the appliance immediately.
-
During using the heater, please do not let the door or window open continually otherwise it will influence the heating effect.
-
If want to close the machine, press the on/off switch to off, then the machine will keep the fan working 15 seconds until it blowing out cool wind, then the machine will stop working, and you may put off the plug-in.
-
Do not use this heater in bathroom or in other wet environment!
-
Timer sets the heater working hours.
-
For the infrared remote controller, please use CR2025 battery.
-
The battery must be removed from the appliance before disposing it.
-
The heater must be installed at least 2 m above the floor, see below sketch.
-
If the product needs repair, do not try to repair it yourself. Please ask for help of a specialst or our company authorized maintenance department.
-
The heater must not be located below a socket-outlet.
-
This appliance can be used by children aged (from 8 years and above) and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge only if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
-
Children of less than 3 years should be kept away unless continuously supervised.
-
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
-
CAUTION – Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present.
Do not cover! Covering the unit can cause overheating, fire or electric shock!
SPECIFICATION
| Heating grade | 1000/2000W |
|---|---|
| Rated power | 2000W |
| Timer | 12 hours settings |
| Weekly program set | available |
| Swing | air deflection available |
| Cable length | 1,7m |
| Control | remote control & touch screen |
| Overheat protection | yes |
| Energy consumption | 2 kW/ hour |
PTC electric heating technology
INSTALLATION
- Drill holes with appropriate size into the wall, at least 200 cm from the floor, along a horizontal line and 420 mm from each other.
- Insert the studs into the holes then drive the enclosed screws into the studs so that the screw heads wall mounted-heater extend approx. 10 mm from the wall surface.
- Hang the unit’s back panel onto the screw heads at the holes, let it down, till stop. Make sure that the heater is hanging securely on the wall!
USING THE APPLIANCE
- Put the plug in the wall socket, and switch “on” the main switcher. The LED touch screen is working.
- Press the On/Off button on the screen to start the heater.
- After you stop the appliance – it would cool down itself for 15 sec by ventilator.
:Quick heating switch “ ”1000W, “ ”2000W
: Set temperature : 18-45 °C (on fig. 25)
: Timer
: Swing function
on/off & heat power button, after
turn off, the appliance cool down itself for 15sec by ventilator
set temperature: between 18-45 °C
timer (1-12 hours), when weekly
timer is working, cannot use this function
swing button: on or off
Cancel: You can cancel the weekly program any time with pressing “Set” & “Cancel”. Weekly timer: To use this function please set actual date and time.
Press “Set” to fix actual day. Use “ ” buttons to set the actual day (MON –
Monday, TUE –Tuesday…). Press “OK”, then “00” will visible on display. Set the
actual time with “ ”buttons. Press “OK” again then set the temperature, repeat
this until you fixed the time and temperature for all days.
After you finish setting time & temperature for each days press “OK” then
program is active.
You can always use other functions while weekly program is active these
functions pauses the weekly program process, if you switch off these
functions, the exact time and day can be read on the display again, then the
weekly program is active again.
When you turn „off” main switcher and unplug the appliance , the set time and program will lost.
CLEANING AND MAINTENANCE
- If you do not use the heater for a long time, please wipe the surface with a soft cloth.
- Wait for the appliance to cool down itself (15sec), unplug it, and then clean it.
- Wipe with a slightly damp cloth.
- Never wash directly with water!
- Never clean with acid or chemical thinner!
- Before reuse, check that the air outlet not to be dirty.
WASTE MANAGEMENT
Correct Disposal of this product
| This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
Manufacturer/Importer: Vöröskő kft., 8200 Veszprem, Pápai út 36.
CE SYMBOL
The mark is intended to indicate that the product complies with the relevant European Union standards and can be freely marketed in the European Union.
CUSTOMER SUPPORT
www.dyras.hu
Copyright © 2024 The dyras wwe.factory LLC U.S.A.
No parts of the content (including logos, design, photos, text, colour scheem
arrangements, etc.) may be reproduced, reused or redistributed for any
purpose whatsoever, or distributed to a third-party for such purposes, without
the written permission of The dyras wwe.factory LLC.
®= registered trademark of Dyras Europe Kft.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>