TRUCK GT4257 Remote Control High Speed Buggy User Manual

TRUCK GT4257 Remote Control High Speed Buggy

Product Specifications

• Model: GT4257
• Manufacturer: Electus Distribution
• Address: 46 Eastern Creek Drive, Eastern Creek NSW 2766
• Phone: 1300 738 555

Product Usage Instructions

• When unboxing the GT4257, ensure all components are included as per the checklist in the user manual. Follow the step-by-step guide to set up the product in a suitable location with proper ventilation.
• Connect the GT4257 to a power source using the provided power cable. Press the power button to turn on the device. Wait for the device to boot up completely before proceeding.
• Use the included remote control or buttons on the device to navigate through the menu options and settings. Refer to the user manual for detailed instructions on accessing different features and functionalities.

Maintenance and Care

• Regularly clean the exterior of the GT4257 with a soft, dry cloth.
• Avoid using harsh chemicals or abrasive materials that may damage the surface.
• Ensure proper ventilation around the device to prevent overheating.

FAQ

• Q: What is the warranty information for the GT4257?
• A: The warranty is provided by Electus Distribution with details as follows: Address – 46 Eastern Creek Drive, Eastern Creek NSW 2766, Phone – 1300 738 555.

Caution

1. Small parts. Keep out of reach of small children.
2. Please operate in an open field without any wave interference.
3. When a transmitter is low in power, please stop and change batteries immediately.
4. On backout after the removal, please do not place discarded to avoid contamination sanitation.
5. Please store the car and the transmitter in a dry and cool environment.
6. Keep away from fire, and hot or humid environments.
7. If the car battery is wet, be sure to wipe and dry it completely to avoid any damage.

Product Configuration

Remove The Truck Body

• Pull out the pins and remove the body
• Make sure all accessories are properly attached, and remove the protection film from the body before turning on the truck.

Install LED wire

1. Make the LED wire pass through the body bracket.
2. Plug the LED into the front bumper block, then connect the LED wire to the connector on the ESC.

Install Transmitter Batteries

1. Remove the battery cover on the bottom of the transmitter(figure 1)
2. Install 3*1.5V AA batteries( not included) in correct polarities (Figure 2)
3. Close the battery cover (Figure 3)

Notice

1. When installing batteries, please be sure to match the polarities labeled on the battery holder.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.

Charge and Install a Rechargeable Battery Pack

1. Insert the USB charger into the outlet ( figure 4) note the power light turns red.
   • Connect the battery pack to the USB charger (figure 5) note the green light flash.
   • When charging is completed, the green light turns solid.
2. Loosen the latch of the battery cover on the chassis then remove it (Figure 6).
3. Place your fully charged battery in the battery slot. connect the battery connector. Don’t force it, it only goes one way! (Figure 7)
4. Replace the battery cover, and tighten the latch (Figure 8)

USB Charger Precautions

CAUTION

1. The USB charger does not apply the input current higher than 4A
2. When the input current is higher than 4A, the USB charger will enter protection mode, all the lights will turn off.

Transmitter instructions

Transmitter switch instructions

Power Switch

• When pairing for the first time, both the car and the transmitter have to be turned on within 3 seconds to pair the frequency.
• The green LED on the transmitter will solid when pairing is successful, and at the same time LED on the car will turn solid.

Steering Trim

• When the chassis switch is turned on and the front tires are not straight, use the ST.TRIM to adjust the position.
• when the car oversteers to the left, ST.TRIM should be adjusted clockwise.
• when the car oversteers to the right, ST.TRIM should be adjusted anticlockwise.

Throttle trim

• SUGGEST: Please adjust the TH. Trim to the low speed when you play with the car for the first time to avoid damaging the car.

OPERATION

1. ALWAYS turn on your transmitter before you turn on the receiver in the vehicle. Always power off the receiver before turning your transmitter off.

2. ALWAYS operate your vehicle in a wide-open area.
   Operating the vehicle on a slippery floor or indoors may crash because of the high speed.

3. WARNING: X9115, X9116, and X9120 waterproof features, please be cautious that the water level should be lower than the bottom of the truck. If an excessive amount of water gets into the body of the truck and causes damage or other related problems, We will not be responsible for such damages.
   Customers will be responsible for any replacements and additional accessories if needed.

4. ALWAYS start at low speed, or the vehicle may slip or run on curves. (as shown on Pie 1 ) NEVER operate your vehicle in max speed. Operating the vehicle in the highest speed may hurt you and damage your vehicle.

MOTOR CARE

• Seat the motor brushes by driving smoothly on a flat surface during the use of the first battery charge. Failing to do so can greatly reduce motor performance and functional life.
• Prolong motor life by preventing overheating conditions. Undue motor wear results from frequent turns, stops, and starts, pushing objects, driving in deep water and tall grass, and driving continuously uphill.

TROUBLESHOOTING

WARRANTY INFORMATION

• Our product is guaranteed to be free from manufacturing defects for 12 Months.
• If your product becomes defective during this period, Electus Distribution will repair, replace, or refund where a product is faulty; or not fit for the intended purpose.
• This warranty will not cover modified products; misuse or abuse of the product contrary to user instructions or packaging label; change of mind and normal wear and tear.
• Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
• You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and failure does not amount to a major failure.
• To claim a warranty, please contact the place of purchase. You will need to show a receipt or other proof of purchase. Additional information may be required to process your claim.
• Any expenses relating to the return of your product to the store will normally have to be paid by you.
• The benefits to the customer given by this warranty are in addition to other rights and remedies of the Australian Consumer Law concerning the goods or services to which this warranty relates.

This warranty is provided by

• Electus Distribution
• Address 46 Eastern Creek Drive, Eastern Creek NSW 2766
• Ph. 1300 738 555

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>