SPORTS ATTACK SB-JHBBbracketkit Baseball And Softball Pitching Machines Installation Guide
- June 24, 2024
- SPORTS ATTACK
Table of Contents
SPORTS ATTACK SB-JHBBbracketkit Baseball And Softball Pitching Machines
Specifications
- Product: Baseball & Softball Pitching Machines
- Manufacturer: Sports Attack LLC.
- Contact: 800.717.4251
- Website: www.sportsattack.com
FAQs
- Q: What tools are needed for installing the Ball Protection Guard Kit?
- A: You will need a 3/8 Ratchet, a 3/8 x 8 extension, a 7/16 socket, and a 7/16 wrench.
Kit And Tools
Kit includes:
- 1 – Ball Protection Guard
- 2 – 1-1/4” Threaded Bolts
- 3 – Washers
- 2 – Nylon Nuts
Tools needed:
- 3/8” Ratchet
- 3/8” x 8” extention
- 7/16” socket
- 7/16” wrench
Installation Instructions
- STEP 1: Turn the on/off switch “OFF” and unplug the power cord. On controller side of machine, loosen bolt and remove wire clamp. Reinstall the wire clamp with 1-1/4” bolt from kit.
- STEP 2: Go to opposite side of machine and remove the nut and bolt (B) from the lower portion of the wheel guard and replace with 1-1/4” bolt from kit. Upper bolt (A) was already removed and replaced with 1 -1/4” bolt from kit, in Step 1.
- STEP 3: Install the new guard and the upper and lower bolts, washers and nuts. On upper bolt use washer then nut. On lower use one washer on each side of the wheel guard.
- STEP 4: Move the throwing head up and down to make sure wires hold in place and double-check the tightness of the nylon nuts on the guard.
Contact
SPORTS ATTACK LLC.
- 800.717.4251
- www.sportsattack.com
For questions or further assistance please call our customers service department at 800.717.4251.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>