VOLTCRAFT 2264187 Desktop Switch-Mode Power Supply Instruction Manual
- June 3, 2024
- VOLTCRAFT
Table of Contents
VOLTCRAFT 2264187 Desktop Switch-Mode Power Supply
Operating Instructions
DESKTOP SWITCH-MODE POWER SUPPLY
Item No. 2264187
Item No. 2266528
Intended Use
The product serves as voltage supply for low-voltage devices with matching DC
jacks. It is intended for connection to common household mains voltage (100 –
240 V/AC, 50/60 Hz). A galvanic separated DC voltage is applied to the output.
The power consumption of the consuming device many not exceed the nominal
voltage of the respective product (depends on the type). The product has a
protection against short circuit and overload.
It is intended for indoor use only. Do not use it outdoors. Contact with
moisture, e.g. in bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this
product. If you use the product for purposes other than those described above,
the product may be damaged. In
addition, improper use can result in short circuits, fires, electric shocks or
other hazards. Read
the instructions carefully and store them in a safe place. Make this product
available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements.
All company names and product names are trademarks of their respective owners.
All rights reserved.
Delivery Content
- Power supply
- Power cord
- Operating instructions
Up-to-date Operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan
the QR code shown. Follow the instructions on the website.
Explanation of Symbols
- The symbol with the lightning in the triangle is used if there is a risk to your health, e.g. due to an electric shock.
- The symbol with the exclamation mark in the triangle is used to indicate important information in these operating instructions. Always read this information carefully.
- The arrow symbol indicates special information and advice on operation.
Safety Instructions
Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.
-
General Information
-
The device is not a toy. Keep it out of the reach of children and pets.
-
Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
-
Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, steam and solvents.
-
Do not place the product under any mechanical stress.
-
If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. Safe operation can no longer be guaranteed if the product:
-
is visibly damaged,
-
is no longer working properly,
-
has been stored for extended periods in poor ambient conditions or
-
has been subjected to any serious transport-related stresses.
-
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
-
Never touch the device with wet or moist hands. There is a danger of electrocution.
-
On commercial premises, the accident prevention regulations of the relevant professional insurance association for electrical systems and operating materials are to be observed.
-
Operation in unfavourable ambient conditions is not permitted. Adverse ambient conditions are:
-
moisture or excessive humidity
-
dust and combustible gases, vapors or solvents
-
Since the device generates heat when operating, ensure that it is adequately ventilated. The housing must not be covered!
-
Never use the product immediately after it has been brought from a cold room into a warm one. The condensation generated could destroy the product. The power supply unit also involves danger to life by electric shock!
Allow the device to reach room temperature before connecting and using it. This may take several hours. -
Power units are not designed for application to human beings or animals.
-
Consult an expert when in doubt about the operation, safety or connection of the appliance.
-
Maintenance, modifications and repairs must only be completed by a technician or an authorized repair center.
-
If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.
-
-
Connected devices
- Also observe the safety and operating instructions of any other devices which are connected to the product.
Operation
Periodically check the technical safety of the device, e.g. check for damage
to the housing etc.
Always lay the cables so that nobody can trip over or become entangled in
them. This poses a risk of injury.
- Connect the DC plug of the power supply with the DC jack on the low-voltage device.
- The polarity cannot be altered. The plug has the fixed polarity „inside plus (+), outside minus (-)“.
- Make sure that the consumers are switched off when connected to the power supply.
- Connect the power cord’s mains plug to a standard mains outlet.
- Correct operation is signaled at the power supply by a LED.
- To remove the consumer, proceed in reverse sequence.
Troubleshooting
By purchasing the power supply you have acquired a product that has been designed to the state of the art and is operationally reliable. Problems and malfunctions can occur nevertheless. We would therefore like to show how you can rectify certain faults yourself:
Observe the safety instructions by all means!
| Problem | Cause | Solution |
|---|
The power indicator is not lit.
|
No mains voltage
| Check the circuit breaker of the power outlet.
Check that all plugs are properly plugged in.
Power supply overloaded.| Remove the consumer and check the technical data.
Care and Cleaning
- Disconnect the product from the mains before each cleaning.
- Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can cause damage to the housing and malfunctioning.
- Clean the product with a dry, fiber free cloth.
Disposal
This symbol must appear on any electrical and electronic equipment placed on
the EU market. This symbol indicates that this device should not be disposed
of as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and
accumulators, which are not enclosed by the WEEE, as well as lamps that can be
removed from the WEEE in a non-destructive manner, must be removed by end
users from the WEEE in a non-destructive manner before it is handed over to a
collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):
- in our Conrad offices
- at the Conrad collection points
- at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the Electro
End users are responsible for deleting personal data from the WEEE to be
disposed of.
It should be noted that different obligations about the return or recycling of
WEEE may apply in countries outside of Germany.
Technical Data
-
Data according to EU regulation 2019/1782
Manufacturer| Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirsch au
---|---
Commercial registration number| HRB 3896
Model identifier| FPPS 12-27W-N (2264187)| FTPS 12-36W-N (2266528)
Input voltage| 100 – 240 V/AC| 100 – 240 V/AC
Input AC frequency| 60/50 Hz| 60/50 Hz
Output voltage| 12.0 V/DC| 12.0 V/DC
Output current| 2.25 A| 3.0 A
Output power| 27.0 W| 36.0 W
Average active efficiency| 87.1 %| 88.6 %
Efficiency at low load (10 %)| 80.0 %| 86.2 %
No-load power consumption| 0.10 W| 0.07 W -
Item No. 2264187
Dimensions (W x H x D) …………………………….. 100 x 31 x 51 mm
Weight …………………………………………………….. 261 g -
Item No. 2266528
Dimensions (W x H x D) …………………………….. 116 x 32 x 50 mm
Weight …………………………………………………….. 285 g -
Both modes
Cable length …………………………………………….. 1.8 m each
Plug Ø ……………………………………………………… 5.5 mm (outer) / 2.1 mm (inner)
Operating conditions ………………………………….. 0 to +35 ºC, 20 to 85 % RH
Storage conditions …………………………………….. -20 to +50 ºC, 10 to 90 % RH
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>