RF Industries RFT-1218 Coax Connector Instruction Manual
- June 13, 2024
- RF Industries
Table of Contents
RF Industries RFT-1218 Coax Connector
Package Content
-
BODY
-
PIN
-
CRIMP FERRULE
ASSEMBLY INSTRUCTIONS
Step 1: Cut end of cable evenly. Strip cable to dimensions shown in
catalog or on outline drawing. All cuts are to be clean and square. Do not
nick braid or center conductor when cutting. Slide ferrule over cable. If
using strain relief or heat shrink tubing slide onto cable first.
Step 2: Pre tin cable conductor If using stranded cable {If needed).
Slide pin onto center conductor until It yields against the cable dielectric.
Solder or crimp pin in place.
Step 3: Slide ferrule stud under braid, while Inserting the pin Into the
body until It yields In place.
Step 4: S lide the ferrule over the braid until It yields against the
back of the connector. Crimp the ferrule with crimp tool as specified on
connector drawing. Trim any extra braid extending out of ferrule end.
Customer Support
RF CONNECTORS
7610 Miramar Road, San Diego, CA 92126-4202 –
858-549-6340
800-233-1728 – Fax
858-549-6345 E-mail:
rfi@rfindustries.com –
www.rfindustries.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>