SEASONAL LLC RGBW Wreath and Garland Instructions
- June 16, 2024
- SEASONAL LLC
Table of Contents
**SEASONAL LLC RGBW Wreath and Garland Instructions
**
RGBW Wreath and Garland Instructions
Branch Shaping
This holiday decoration is shipped from the factory with the branch tips
compressed to the center. Each of the branch tips must be shaped to their
proper position to give the product its finished and natural appearance.
Proper shaping will also bring the product to its advertised dimension. The
care and detail given to the branch shaping process will result in an
attractive and appealing decorative holiday piece.
Shaping is performed by gently grasping each branch tip and spreading it out away from the center. Work your way around the piece pulling branch tips into position to create the desired look.
Battery Installation
Open the battery compartment and insert the required batteries. Be sure to
observe proper polarity (+/–).
Light Operation
An included handheld remote control operates the various light colors and
functions. See diagram below.
Storage
To avoid corrosion and leakage, remove the batteries from battery compartment
before storage. Store the product in a cool, dry location, protected from heat
and sunlight.
WARNINGS
- This product is for seasonal decoration only and not intended for permanent installation or use.
- Do not mix old and new batteries. Replace all batteries at the same time.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel cadmium) batteries or equivalent.
- Do not use rechargeable batteries.
- Do not dispose of batteries in fire. Batteries may explode and cause injury.
CAUTION: changes or modifications not expressly approved by the party
responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Remote Control Operation
Be sure to aim the remote control at the product. Button Descriptions:
ON: Turns ON lights.
OFF: Turns OFF lights; cancels timer. TIMER: Turns lights ON for 6 hour
period followed by 18 hours lights OFF period in a continually repeating
sequence.
TIME OFF: Cancels Timer.
OFF: Turns OFF lights; cancels timer.
R: Turns lights RED.
G: Turns lights GREEN.
B: Turns lights BLUE.
W : Turns lights WHITE.
MODE: Cycles to the next mode after each press.
AUTO: Automatically cycles to next mode after previous mode completes.
CHASING: Lights fill from one side to the other with each cycle changing
color.
CHASE FLASH: Series of different colors moving in a chasing motion.
FLASH: All lights flash ON for 3 second cycle then change color each
time.
FADE: All lights fade ON and OFF changing color each time.
FILL: Series of lights move through until accumulating to light entire
piece, changing color each time.
WAVE: Continuous series of color lights move across
SAVE THESE INSTRUCTIONS
Seasonal LLC Closter, New Jersey 07524 www.seasonalllc.com