ARGOX MX-300 Series Barcode Label Printer Installation Guide
- June 15, 2024
- ARGOX
Table of Contents
ARGOX MX-300 Series Barcode Label Printer
Specifications
- Model : XM4-200/300 MX-200/300 Series
- Revision Date : April 2024
- Manufacturer : Argox Information Co., Ltd.
- Version : v1.0
Product Usage Instructions
Quick Installation Guide
Follow these steps to quickly install the peeler accessory for your
XM4-200/300 or MX-200/300 Series:
- Start by identifying the parts and accessories mentioned in the guide.
- Locate the peeler cable and peeler connector.
- Insert the peeler cable into the designated hole on the device.
- Connect the peeler connector to the device.
- Repeat steps 2-4 for each side of the device if required (as indicated by ‘x2’ or ‘x5’).
Troubleshooting
If you encounter any issues during installation, refer to the troubleshooting
section of the user manual for solutions.
FAQ
Q: Can I use the peeler accessory with other models?
A: The peeler accessory is specifically designed for use with XM4-200/300 and
MX-200/300 Series models. It is not recommended for use with other models.
Q: How do I know if the peeler is installed correctly?
A: Ensure that the peeler cable is securely inserted into the designated holes
and that the peeler connector is properly connected. Refer to the installation
guide for detailed instructions.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>