ARGOX LK-300 Mid Range Barcode Label Printers Installation Guide
- June 1, 2024
- ARGOX
Table of Contents
ARGOX LK-300 Mid Range Barcode Label Printers
Specifications
Model | iX4-280/380, LK-200/LK-300 Series |
---|---|
Revision Date | April 2024 |
Note | Except for the new full cutter, all other cutters DO NOT cut on media |
with glue. For more details, please refer to the cutter specification in the user’s manual. Specifications, accessories, parts, and programs are subject to change without notice.
Installation Steps
- Begin installation by placing the cutter at a 90-degree angle.
- Attach the cutter firmly with two screws as indicated.
- Ensure the cutter is properly aligned and secured in position.
- Secure the cutter’s position with two additional screws.
- Remove the protective cover by unscrewing two screws.
- Locate the cutter cable and hole for installation purposes.
- Insert the cutter cable through the designated hole (Note: Peeler cable also goes through this hole).
- Do not insert cables through any other openings not specified for them.
- Attach the side panel using five screws to secure it in place.
- Remove the back panel by pressing down and sliding out.
- Identify the cutter cable and hole inside the printer.
- Connect the cutter cable to the cutter connector located within the printer.
- Secure the ground wire within the printer for safety.
- Reattach the back panel by sliding it into place.
- Secure the back panel with five screws.
- Ensure that the cutter assembly is firmly in place with two screws on each side.
- Screw at the utmost left and right side of the cutter assembly.
- Check the alignment and assembly of the cutter mechanism.
- Confirm that all parts are installed correctly and functioning.
- Finalize the installation by ensuring all cables and parts are secure.
- Complete the process by replacing the cutter’s protective cover.
Contact Information
Argox Information Co., Ltd.
8F., No. 28, Baogao Rd., Xindian Dist., New Taipei City 231029, Taiwan
(R.O.C.)
Tel: +886-2-8912-1121
Fax: +886-2-8912-1124
https://www.argox.com
https://www.youtube.com/user/argoxmkt
FAQ
What is the revision date of this guide? The revision date is April 2024. Can I cut media with glue using these cutters? No, except for the new full cutter, all other cutters should NOT cut on media with glue. Are the specifications and accessories subject to change? Yes, specifications, accessories, parts, and programs are subject to change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>