NexiGo P5 Wall Mount Set 1548 User Manual
- May 15, 2024
- NEXIGO
Table of Contents
A Wall Mount with
Controller Holders
forP-5
Mode! No: NexiGo-P5
Wall Mount Set 1548
User Manual
NexiGo P5 Wall Mount Set 1548
Register to get EXTRA ONE year warranty. Only valid in registering within 14 days of product delivery. nexigo.com/warranty
http://www.nexigo.com/warranty
Welcome to the Nexi Go Family!
Thank you for choosing the NexiGo 1548 Wall Mount with Controller Holders for
the P-51 You are now part of an exclusive clubs the Nexis Go family It our job
to make sure you enjoy your membership. four have any problems please contact
us at cs@nexigo.com at any time for further
assistance. This product is covered by our industry leading 1-year
manufacturers warranty. Register at
nexigo.com/warranty or scan the QR code to get a
FREE additional year warranty From all of us here at NexiGo, we want to
welcome you again to the family. We thank you deeply for your trust and for
your business. We know you’ll love it here. We look
forward to serving you again in the near future.
‘Yours Sincerely,
‘The NexiGo Team
Contact Information:
Website: www.nexigo.com
Manufacturer: Nexight INC
Email. csanexigo.com
Tel: +1(458) 215-6088
Address: 11o75 SW 11th St, Beaverton, OR 97005, US
Product Introduction:
The NexiGo 1548 Console Wall Mount with Controller Holders is designed
exclusively for the P-5 console.
and is compatible with both Digital and Disc editions.
Simply attach the wall mount using the included screws and wall anchors for a
secure, stable installation. It provides easy access to the console and
controllers while keeping them secure. so you don’t have to hide your new toys
in your entertainment center or worry about breaking them!
What’s in the Box:
Installation Guide:
Step1:
Position the console wall mount at an appropriate location on the wall and then locate the screw holes in the wall mount. Use a level (NOT INCLUDED), to make sure that the mount is level on the wall. Mark each hole carefully with a pencil or pen to ensure that the item is mounted in the correct location. Once you have marked the holes, repeat this process with the controller holders, (See below for alternate mounting instructions for the controller holders.)
Step2: Drill a hole at each mark (Drill and drill bit NOT INCLUDED).
Step 3:
Insert a wall anchor into each hole and hammer in the wall anchors so they are nearly flush with the wall surface. (Hammer NOT INCLUDED)
Step4:
Insert screws into the wall anchors, but do NOT fully insert the screws
into the wall. Leave approximately % to % of an inch of the screw sticking out
of the wall.
Step 5
slide the console wall mount and controller holders onto the screws, and then
slide the items down to ensure they are firmly attached.
Step 6:
Tighten the screws with the provided screwdriver to ensure that the console
wall mount and controller holders are firm and secure. The controller holders
and console wall mount are both ready to use!
Step7:
Place the P-5 console on the console wall mount and affix the console to the
mount using the provided P-5 connector screw.
Alternate Installation Instructions-Controller Holder:
Step1:
Clean the surface where you want to place the controller holder. (Sticker may
remove paint. Use with care)
Step 2:
Peel the backing from one side of the mounting tape and apply the mounting
tape to the controller holder a5 shown in the image below.
Step 3:
Once the mounting tape is attached to the controller holder. remove the other
sidle of the mounting tape backing. Locate the spot you want to attach the
controller holder, and then carefully press the controller holder into place
in that location. Press and hold firmly for 30 seconds to secure the
controller holder where you are mounting it to,
Step
4:
After the controller holder is attached, please wait about an hour before
using the item to make sure the controller holder is firmly attached. The glue
will require some time to bond in place, using it before this has happened may
cause the gigue to fail and this could damage the controller, wall. or mount.
After waiting an hour, the controller holders will be ready to use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>