SWRMT-39N
Radio Replacement with Steering Wheel Control Retention for
Select Mitsubishi Vehicles 2008 – 2019

Product Features

• Retains factory features in select Mitsubishi vehicles while functioning with an aftermarket radio.
• Pre-programmed to retain factory Steering Wheel Controls.
• Retains factory Auxiliary input for vehicle if equipped.
• EIA color coded wiring for easy installation.

Parts included

Installation Diagram

DIP Switching Settings

Aftermarket Radio Dip Switch Settings

NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most off brand radios, check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.

Mitsubishi Steering Wheel Control Dip Switch Setting

3.SMM SWC Cable

Plug in the 3.SMM to 4-Pin SWC cable and set the DIP switches to the aftermarket radio you are using.

NOTE: Insulate the Blue/Yellow wire or the 3.5mm plug if not being used.

For aftermarket radios that have wires for SWC connections, cut off the 3.5mm plug on the Crux SWC Cable and connect the SWC wires as follows:

Note that there are some radios that only have SWC1 and SWC2, in this case “shield” does not need to be connected.

Vehicle Applications

MITSUBISHI

2008-2017 Lancer
2008-2015 Lancer Evolution
2014-2019 Mirage
2008-2019 Outlander
2011-2019 Outlander Sport
NOTE: Not compatible with vehicles equipped w/ factory Nav
Not compatible with vehicles that have Rockford Fosgate

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: 818-609-9299 • fax: 818-996-8188 • www.cruxinterfacing.com

SWC troubleshoot option

Located internally t Need to take plastic Casing off module

1. If steering wheel controls don’t Work/vt1ork properly please S’vvitch internal dip switch from 3v3 to 5v as shown in picture above

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>