FSR VIP-100 Power Supply Preparation Instruction Manual
- June 11, 2024
- FSR
Table of Contents
FSR VIP-100 Power Supply Preparation
Specifications
- Model: VIP-100 POWER SUPPLY
- Manufacturer: FSR Inc.
- Length of Power Cable: Not specified
- Design: Polarity is not important
Product Usage Instructions
-
Step 1: Cutting the Jumper
Cut off a 5-inch length from the power cable to use as a jumper. -
Step 2: Stripping Insulation
Strip insulation back 3/16 inches from the end of the cables. -
Step 3: Joining the Jumper
Join the jumper to the power cable end in a parallel connection as shown. -
Step 4: Inserting Cables
Insert the cables as shown so that the jumper feeds power to both devices. Polarity is not important due to the unit’s design. -
Step 5: Securing Connections
Screw down the connections and tug on them to check for loose cables.
USING INSTRUCTION
- Step 1. Cut off a 5” length from the power cable to use as a jumper.
- Step 2. Strip insulation back 3/16” from the end of the cables
- Step 3. Join the jumper to the power cable end in a parallel connection as shown
- Step 4. Insert the cables as shown so that the jumper feeds power to both devices. Due to the unit’s design, the polarity is not important.
- Step 5. Screw down the connections and tug on them to check for loose cables.
FSR Inc.
- 244 Bergen Blvd.
- West Paterson NJ 07424
- Ph 973-785-4347 Fax 973-785-4207 www.fsrinc.com
FAQ
- Q: Is the polarity important when connecting the jumper?
- A: No, due to the unit’s design, the polarity is not important when connecting the jumper.
- Q: How long should the jumper be cut from the power cable?
- A: Cut off a 5-inch length from the power cable to use as a jumper.
- Q: What should I do if I find loose cables after connecting?
- A: If you find loose cables after connecting, unscrew the connections, reinsert the cables securely, and screw them down again.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>