FSR CB-22P Fan Kit Instruction Manual
- June 1, 2024
- FSR
Table of Contents
CB-22+/CB-22P+ Fan Kit
Installation Instructions
CB-22P Fan Kit
Door Removal (CB-22+/CB-22P+)
1. Turn latch to open door (unlock if needed). (a) Push door up towards
ceiling and (b) push towards shelf – reverse procedure to install. Disconnect
safety cable to completely remove door. Fan Installation (CB-22+)
2. a. Install Fan Kit assembly as shown (shelf not shown for
clarity). Fan Installation
(CB-22P+)
b. Install Fan Kit assembly as shown (shelf must be removed to install fan
kit). Fan Control Board
Installation (CB-22+/CB-22P+)
3. Install Fan Control Board as shown noting orientation (Fan not shown for
clarity). Connect 3 pin harness from Fan to mating 3 pin connector on Fan
Control Board. Plug AC adapter into unused receptacle and connect 2 pin
harness to mating 2 pin connector on Fan Control **Board.![FSR CB 22P Fan Kit
- Figure 4](https://manuals.plus/wp-content/uploads/2024/05/FSR-CB-22P-Fan-
Kit-Figure-4.jpg) Note: Fan will only run when temperature within unit
exceeds 30C/86F. Fan speed will increase as internal temperature increases and
reach its maximum airflow at 40C/104F.
Foam Installation (CB-22P+ ONLY)**
4. Install adhesive foam to door as shown.
244 Bergen Boulevard, Woodland Park, NJ 07424
Phone: 973.785.4347 – Fax: 973.785.4207
LIT1891
43470
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>