speechi SUP-MOB-MAN-002 Stand User Manual
- June 12, 2024
- Speechi
Table of Contents
speechi SUP-MOB-MAN-002 Stand
Material List
- To make sure we use the stand correctly and safely, please read this instruction carefully before installation.
- Max bearing weight is 100KG.
Assembly Step
Step 1: Assemble the casters
Adjust the casters to the brake state, and then tighten the 4pcs casters on
the base.
Step 2: Assemble the base
Place the base on the ground and keep the longer side ahead, place the column
on the base and tighten the screws.
Step 3: Assemble the handle
Insert the handle into the column from the back and secure it from the front
using a screw lock.
Step 4: Assemble the Hex rod
First, install the Hex rod into the hexagonal hole of the Lift column-L, and
then, when installing the right side, you need to tilt the Lift column-R to
align the hexagonal hole and install it. In this time, we can lock all the
screws at the bottom of the column.
Note : we can rotate the handle slightly if the hexagonal rods can’t be
inserted into the column-R.
Step 5: Assemble the cover bracket, align the holes and use screws -c to fix.
Step 6: Assemble the wall mount
Place the screw through the wall mount and column, put on flat washer and nut
on the other side,and tighten it with wrench.
Step 7: Hang the assembled machine with the wall mount bracket, and lock the safety screw -e.
Make sure the screws are locked before using.
Step 8 : Refer to the figure below for the effect after assembly.