ORTUR OLM3 Laser Engraving and Cutting Machine Instruction Manual
- June 11, 2024
- ORTUR
Table of Contents
OLM3 Laser Engraving and Cutting Machine
Instruction Manual
OLM3 – Laser Module
Install the Laser Shield
First let the right long clip enter the long slot. After the long clip is
fixed, press the left side firmly so that the short clip enters the short
slot.
Press the position of the arrow, do not press the short clip directly to avoid
the risk of breakage!
How to find focus
Loosen the thumb screw, let the laser module move down until the
focus stick is against the engraved object,and then tighten the thumbscrew to
fix the laser module. After focusing, you must put away the focus stick to
avoid breaking the focus stick!
How to air compressor
Tip: No need to install air
assist when not using an air compressor.
Reinstall the laser shield.
Tip: When not using the air compressor, please install the rubber
plug!
Cut into two parts, one part is used
to connect the laser module and the air flow regulator, and the other part is
used to connect the air flow regulator and the pipe joint or the air
compressor. Press firmly on the position indicated by the arrow until the air
pipe is fully inserted and released. 
Maintenance
Please clean the lens after every 30 hours of use of the machine or after a
long period of inactivity to prevent the laser from being intercepted by the
dust attached to the lens. Use a medical swab and alcohol to wipe the lens.
Company: Dongguan Ortur Intelligent Technology Co., LTD.
Address: Building 4, No. 6, Tianheng Road, Changping Town, Dongguan City,
Guangdong Province
|
---|---
https://www.youtube.com/channel/UCumaMbcd6-apV_TLdhZZRwg|
https://www.instagram.com/ortur_tech/
|
https://twitter.com/ORTUR_TECH|
https://www.facebook.com/profile.php?id=61551343617499
|
https://support.orturtech.com/|
www.orturtech.com
MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>