SHOCKFLG TP03 Tire Inflator Portable Air Compressor Instruction Manual

SMART PORTABLE
AIR INFLATOR TP03
USE & CARE INSTRUCTIONS

If  you have any questions, please cobtact our emill address.
Please read all instructions carefully before use

Quick User’ Manual

| Take out the air pipe from the bottom to connect with the car tire valve.
---|---
| Connect to the car cigarette lighter power cable.
| Start the car and the tire inflator will start up automatically.
| Select one appropriate mode from the five options and adjust the pressure to target value with + or – buttons. Press to ****start pumping.
| The tire inflator will stop when the target pressure is reached. Press the Off button to shut down the tire inflator.
| Collect and wind the air pipe to its original position, and collect the car cigarette lighter cable.

■ Instructions on the air valves

■ Key Considerations:

1. Please keep the vehicle in the starting state when using the power cord of the cigarette lighter to take power;
2. Please connect the trachea correctly to avoid air leakage;
3. When the cigarette lighter is not turned on when the product is connected, please check whether the cigarette lighter is connected and whether the car is in the started state;
4. If there is no work or other operation for 2 minutes in the middle, it will be automatically shut down, and the device can be turned on by clicking the power switch button.

Precautions

1. The tire inflator is not a toy. Children are not allowed to use it. Operators should be older than 16 years old. During operation,please keep it out of the reach of children.

2. ADC motor is embedded in the tire inflator. Sparks may be generated during operation, and do not use it in flammable and explosive environments.

3. Shut down the tire inflator in the case of abnormal noise or over tempe rature.

4. Make sure that you have selected the correct unit of measurement before setting up the inflation pressure value, otherwise it may lead to accidents such as tire
   Common unit conversion is as follows: 1 bar = 14.5 psi, 1 bar = 100 kPa, 1 bar = 1.02 kg/cm².

5. Keep the tire inflator attended while the inflation is in process. Observe the process to prevent over inflation.

6. To maintain the service life of the tire inflator, it is not allowed to work consecutively for more than 30 minutes.

7. Keep the power cable of the tire inflator away from water and other liquid.

8. Use the tire inflator as instructed in the User’s Manual. For any problem, please contact us at support@shockfia.com.

List of accessories

Descriptions

level, mode and unit
⑤| Control buttons| Ten touch-control buttons
⑥| Lights| Three lighting modes

■ Descriptions of LED display andtouch-control buttons

psi
⑩| Preset regular tire pressure| Presetting regular tire pressure at 35 psi
11| Preset fortified tire pressure| Presetting fortified tire pressure at 40.5 psi
12| Lighting buttons| Lighting mode, 2. Red/blue warning lights, 3. SOS strobe signal light
13| Pressure addition| Increasing the set pressure
14| Pressure deduction| Decreasing the set pressure
15| Startup button| Pressing to start or pause the pumping
16| Setup of pressure unit| Pressing to sat pressure unit (psi, bar, kPa, kg/cm2)

Parameters

Product recommended inflation pressure

The recommended inflation pressure is for reference onl. Please refer to the Instruction Manual of the product for the specific inflated pressure.

Check the connection between the air pipe and the tire.
Check the leakage at the tire.
Inflation failure| Check the damage on the tire and the connection between the air pipe and the tire.
If the inflation failure is on balls, check whether the pump needle is planted too deep in the ball or whether the threaded end of the pump needle is aligned with the air valve.
Inflation startup failure after the pressure is set| Check whether the current tire pressure is higher than the set pressure.
Operation failure of the tire inflator after connected with the car cigarette lighter power supply| Check the lighter for abnormality.
Check the fuse in the lighter for abnormality.
Automatic shutdown when the air pipe is connected| The tire inflator is set with automatic shutdown without operation in 2 minutes. Tap the switch to restart the tire inflator.
Air leakage when the air pipe is connected| Screw the air pipe tight or check whether the air pipe is correctly connected.
Pressure drop at the tire| When the pressure reaches 36 psi during the pumping, the pressure may drop by 1 – 2 psi. There are pressure differences between the exhaust and inlet holes.
Automatic shutdown after operation for a long time| This fault may be resulted from over-temperature protection after long-term operation. Cool down the tire inflator for 5 – 10 minutes and restart it.
Over-heat| The tire inflator cannot be operated for long periods of time. It is advised to operate the tire inflator for 10 minutes at a time, followed by a 5-minute break.

If the above faults persist or other faults occur, contact us atsupport@shockflo.com.

If you have any questions, please contact our email address.
CERTIFICATION OR TEST:
FCC / CP65/ CE / ROHS / WEEE / UKCA/ PSE
BRAND: SHOCKFLO
EMAIL: support@shockflo.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>