PHILIPS BVP167 Smart Bright LED Floodlight Instruction Manual

PHILIPS BVP167 Smart Bright LED Floodlight

WHAT’S IN THE BOX

FEATURES

Dimension

• The above lux level threshold is related to outdoor natural light.
• The sensitivity of the sensor can vary in cloudy or other weather conditions.
• Do not place the lamp in areas with severe light obstruction or areas with other direct light.
• The light-emitting surface of the lamp should be far away from the reflecting surface to avoid excessive self-illumination interference.
• Avoid reflected surfaces (i.e. Mirrors, windows, metal)

INSTALLATION INSTRUCTION

• Install the luminaire according to the national regulations.
• 3P terminal, the terminal is at least rated voltage 250V.
• HO5RN-F3x1.0mm? 602451EC57
• N: Blue
• L: Brown
• GND: Yellow-Green
• The terminal block should be complying with EN60998-2- 1/EN60998-2-2
• If the luminaire is higher >3 m, the use of 2nd fixing security system is needed.
• Multi Color   switch: set your colour temperature to 3000K, 4200K (=default)or 6500K
• The luminaire shall be installed or maintained by a qualified electrician and wired under the latest lEE electrical regulations or national requirements.
• The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.
• The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
• Luminaire must not be used or stored in a corrosive environment where hazardous materials such as sulphur, chlorine, phthalates, etc. are present.
• To reduce the risk of strangulation the flexible wiring connected to this luminaire shall be effectively fixed to the wall if the wiring is within arm’s reach.
• Disconnect before servicing
• This product contains a light source of energy efficiency class: see table or label.
• Luminaire has basic insulation between Low Voltage supply and control conductors
• The light source and/or control gear and/or external flexible cable contained In this luminaire are not replaceable, in case of damage replace the luminaire.
• Storage, installation, use, operation and maintenance of the products need to be performed exactly according to the instructions in this manual and/or other instructions as may be provided by us to guarantee safe use of the product over its entire lifetime.
• Failure to adhere to these instructions will invalidate your entitlement to warranty.
• Bolts with the indication of torque strength on the drawing need to be tightened using a calibrated torque wrench.
• Pre-assembled bolts need to be retightened again to the required torque specification to ensure maximum strength over a lifetime.
• SR compatibility – For SR-based luminaires only SR-certified components/sensors are to be used (see also: http://www.lighting.philips.co.uk/oem-emea/products/driving-connected-lighting).
• The functional compatibility of two (SR-certified) components/sensors to be used in combination, as well as the override possibility of any line-switch function used in an SR-based luminaire, is to be released by the master component/sensor supplier.
• If using a NEMA 7-pin socket on an SR-based luminaire, a full system verification is required. Not following this advice can/will cause risk of damage and non-compliance for which Signify cannot take any responsibility.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>