Victorian SM0171-10922L Clicker Waste Brushed Brass Instruction Manual
- June 10, 2024
- Victorian
Table of Contents
Victorian SM0171-10922L Clicker Waste Brushed Brass
Specifications
- Bathtub Thickness Compatibility: 5-15mm
Product Usage Instructions
To ensure proper usage and maintenance of the product, please follow these instructions:
Installation
- Ensure that the bathtub thickness is within the specified range of 5-15mm.
- Provide a plug and washer for the installation.
- Test the overflow pipe for leaks before regular use.
Aftercare
The end user should regularly maintain and clean the product using warm soapy water and a soft cloth. This is necessary to keep the product warranty valid. Surfaces should be maintained using a clean damp cloth. Avoid using corrosive or abrasive agents on the surface finish as it will invalidate the product warranty.
FAQ
- Q : What should I do if the bathtub thickness is not within the specified range?
- A: It is crucial to ensure that the bathtub thickness falls within the specified range of 5-15mm for proper installation and functionality of the product. Using the product outside this range may result in damage or improper fit.
- Q: Can I use any plug and washer for installation?
- A : The user is required to provide a suitable plug and washer for installation. Using incorrect or incompatible parts may lead to leaks or other issues with the product.
Installing steps
- Identify all components are present prior to installation
- of lush pipes to remove any debris in pipes before installation
- Position overflow body (C). Ensure washers (Item D and E) are in place and push the overflow cover (A) into lock nut (B)|
- Assemble waste outlet (J), Ensure washers (Items H and I) and Flange (G) are in place and tightened.
- Fill the bath with water and check all joints to ensure there are no leaks, This is best done in stages starting with a small amout of water before fully filling the bath
- Once fitting has been completed carefully clean all plated surfaces. The finished surface product should be cleaned on a regular basis to maintain their appearance. The product should only be cleaned with warm soapy water and then wiped with a dry cloth
-
Overflow cover
Lock nut -
Overflow body
-
Flat washer-lock nut
-
Flat washer-overflow
-
Cover
-
Flange
-
Washer
-
Washer
-
Waste outlet
-
Rubber seal
-
Plastic spacer
-
Plastic nut
-
Plastic pipe
Once assembled, fill the bath with water, and check for leaks.
The product is suitable for bathtub thicknesses 5-15mm
Aftercare:
The end user is required to regularly maintain and clean the product using
warm soapy water and a soft cloth for the product warranty to be valid.
Surfaces should be maintained using a clean damp cloth, NO corrosive and
abrasive agents or materials should be used or come into contact with the
surface finish, as this will invalidate your product warranty.