Victorian B19879 Traditional 2 Tap Hole Wall Hung Basin Installation Guide
- May 15, 2024
- Victorian
Table of Contents
Victorian B19879 Traditional 2 Tap Hole Wall Hung Basin
Product Information
Specifications:
- Material: Ceramic
- Recommended Height: 800-850mm from tap deck to floor
- Cleaning Instructions: Use a soft damp cloth and mild soap solution, avoid abrasive cleaners
Product Usage Instructions
Fixing Basin
- Ensure the wall is strong enough to support the basin and semi-pedestal.
- Hold the basin up to test and ensure optimum height (recommended 800-850mm from tap deck to floor).
- Make sure the semi pedestal will cover the pipework when placed over and then mark out and drill the holes for the basin.
- Insert the plugs and screws, then tighten with a spanner.
- Place the basin over the screws and use the plastic bushing and nut to tighten into place.
- Tighten evenly by hand and finish off with a spanner.
Aftercare Instructions
- Clean surfaces with a soft damp cloth and mild soap solution.
- Avoid abrasive cleaning agents.
- Do not stand on washbasin.
- Check fixings after a few days to ensure they are still tight.
Cleaning Products
- Use cream cleaner or bleach cleaner for maintenance.
- Avoid abrasive, corrosive, or chlorine-based cleaners as they can damage the product.
Important Notes:
- Periodically check all fixings to ensure none have come loose and re-tighten where necessary.
- Assembly should be carried out by a competent person to avoid damage or injury.
Frequently Asked Questions (FAQ)
Q: Can I use abrasive cleaners on the product?
A: No, it is recommended to avoid abrasive cleaners as they can damage
the surfaces.
Q: How often should I check the fixings?
A: It is recommended to check the fixings after a few days and
periodically thereafter to ensure they are tight.
INSTALLATION GUIDANCE
Please retain for future reference
Please read carefully before attempting to fit the basin and semi pedestal. If you are not the end user, please make sure the aftercare instructions are made available for the end user to read.
Ensure the wall is strong enough to support the basin and semi pedestal. Hold the basin up to test and ensure optimum height (recomended 800-850mm from tap deck to floor). Make sure the semi pedestal will cover the pipework when placed over and then mark out and drill the holes for the basin. The plugs and screws can then be inserted and tightened with a spanner.
Place the basin over the screws and use the plastic bushing and nut to tighten
into place. Tighten evenly by hand and finish off with a spanner.
Once the basin is secure to the wall the tap and waste can be installed.
AFTERCARE INSTRUCTIONS
Clean surfaces with a soft damp cloth and mild soap solution
Do not scrub or scour
Do not use abrasive cleaning agents
Do not stand on washbasin
IMPORTANT
After a few days check that the fixings are still tight. This is necessary as
some components will compress during the first few days.
When using abrasive, corrosive or chlorine-based cleaners, ensure that these
do not come into contact with the fixings. Failure to do so can lead to
discolouration of surfaces or rusting of metal parts which will not be covered
by the guarantee.
Periodically check all fixings to ensure none have come loose and re-tighten
where necessary. Assembly should be carried out by a competent person. No
liability will be accepted for damage or injury caused by incorrect product
installation or assembly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>